Listening To Radio Broadcasts - Technics SC-EH600 Operating Instructions Manual

FM AUTOMONO
4 ™~ TUNING "~\
—=
(When you select "PRESET") i
PRESET :
EA et
+
+ (When you select
i : "MANUAL")
i + (MANUAL TUNED
STANDBI
=
STEREO
FN Be | Quante
(When you select "PRESET") :
(When you select
"MANUAL")
MANUAL REL
TUNERBAND ©
i FM AUTOMONO
i O00
' 0000
i 9000 A
: SC-EHs00
: TUNED EOS \ TUNER
7
MONO
'
BAND
(Ft G0 oa pti! 90
; ooo
ooo
Listening to radio broadcasts
This example in the figure shows how to tune in FM stations.
i Switch on the power.
Press TUNER/BAND to select the desired band.
Each time you press this button, "FM" and "AM" will appear
alternately.
fe] Press TUNING MODE to select "PRESET" or
"MANUAL".
Each time you press this button, "MANUAL" and "PRESET"
will appear alternately.
Select "PRESET" when stations are preset.
(Refer to "Memory presetting" on pages 13 or 14 to preset
stations.)
@Select "MANUAL" when stations are not preset.
4] Press TUNING (v or a) to tune in the desired
broadcast.
"STEREO" lights when an FM stereo broadcast is being re-
ceived.
"TUNED" lights when you precisely tune ina broadcast station.
Automatic scanning (when you select "MANUAL" in
step EB):
Press and hold TUNING (v or ») until the displayed frequency
starts to scroll.
The scrolling of the displayed frequency will automatically
stop if a broadcast station frequency is located during the
tuning process.
When there is excessive interference, automatic scanning may
not function.
To cancel automatic scanning, press TUNING (v or a) once
again.
5] Adjust the volume level.
For tuning by remote control (when you select "PRESET"
in step EJ above):
Specify the channel you want with the numeric buttons (see page 53
or 54),
To select a two-digit channel:
Press 210 and then the two numbers you want within 10 seconds or
$0.
If an FM station is preset to "MONO", the "STEREO" indicator will
not light up even if a stereo broadcast is being received.
lf noise is excessive in the FM stereo mode: £]
Press FM AUTO/MONO.
The sound reception mode switches to "MONO" (monaural) and
"MONO" lights.
The sound will then be heard in monaural. If the broadcast signal is
weak, or if there is a large amount of interference, you will get a
clearer sound using MONO function.
To cancel the "MONO" mode, press the button again.
When "MONO" indicator goes off:
Use this setting for normal listening. Both stereo and monaural
sounds can be heard as they are.
Ifyou change frequencies in the "MONO" mode, the "MONO" mode
will be cancelled.
-—— One-touch play E]
When the system is OFF, you can receive the station last tuned
in when you press TUNER/BAND on the remote control.
Play will start with volume increasing gradually.
g
2
3
&
5 8
a