SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE. Intended use The Timberline S-Series walk-behind scrubber is intended for commercial applications with hard floor surfaces such as concrete, vCT, tile and grout, stone, ect. This machine is not designed to clean carpets or sand wooden surfaces. Use only OEM pads/brushes and commercially available floor cleaning detergents.
Tank or pick up. to explode. Serious personal injury or property damage could occur. Only charge the Batteries in this machine in a well ventilated area. TIMBERLINE S-SERIES v23341 Questions? Call 855-965-0011 Use OEM Parts...
Do not operate this machine if any parts have been controller. damaged or removed. CAUTION To avoid damage to the electronic control components of this machine, Do not store this machine outdoors. Do not pressure wash this machine. TIMBERLINE S-SERIES v23341 Questions? Call 855-965-0011 Use OEM Parts...
OPERATION Flushing Recovery Tank Approved Drains Only Approved Drains Only Approved Drains Only Approved Drains Only TIMBERLINE S-SERIES v23341 Questions? Call 855-965-0011 Use OEM Parts...
3000 Grit HD Non Woven Polishing Pad 6000 Grit Diamond Poly Pad Tile/Grout Renovator Pad EDGE-4069 Dominator HD Strip Pad EDGE-4006 Maroon ECO Prep Pad EDGE-4007 EDGE-2407 Microfiber Pad EDGE-4036 EDGE-2436 TIMBERLINE S-SERIES v23341 Questions? Call 855-965-0011 Use OEM Parts...
Squeegee blade kits include (1) Rear Blade, (1) Front Squeegee Assemblies (complete) listed above all come Blade, and (2) Caster Wheels with hardware. with Linatex blades. NOTICE Size is denoted by label on top squeegee. TIMBERLINE S-SERIES v23341 Questions? Call 855-965-0011 Use OEM Parts...
Please refer to OEM Charger Operating Instructions for more information. Onboard / AGM / International Chargers: AC Power: 80-270vAC / 50-60Hz DC Power OUT: 24vDC / 25A Please refer to OEM Charger Operating Instructions for more information. TIMBERLINE S-SERIES v23341 Questions? Call 855-965-0011 Use OEM Parts...
Make sure the controller connections are secure. 10 Flash An excessive voltage has been applied to the controller. This is usually caused by a poor battery connection. Check the battery connections. TIMBERLINE S-SERIES v23341 Questions? Call 855-965-0011 Use OEM Parts...
To restore the standard functionality, disconnect the Charger from the AC plug and be sure the inhibit signal from the charger to the controller is removed. TIMBERLINE S-SERIES v23341 Questions? Call 855-965-0011 Use OEM Parts...
Need help?
Do you have a question about the S Series and is the answer not in the manual?
Questions and answers