Related Manuals for Teamson Home RJ-23063
Summary of Contents for Teamson Home RJ-23063
- Page 4 1. This solar pump is designed for fountain, pond, or outdoor use. The solar panel needs to be in direct sunlight for full power to operate the pump. When the solar panel is in a shadow or the sunlight is weak, the pump will not operate. 2.
- Page 5 Pump: If the pump starts to lose power or stops working, check for the build-up of sediment, scale, or dirt in the pump. Remove the pump filter, the gland, and the rotor. Clean them with a stream of fresh water and a small brush if needed to remove the debris. Solar Panel: The panel should be cleaned periodically with a soft tissue to maintain optimum conversion of sunlight into solar power.
- Page 6 1. Do not strike the solar panel. 2. Do not let the pump run dry. 3. If the fountain is not in use for a long period of time: a. Always disconnect the pump from the solar panel. b. Fully charge the panel for 2 days before turning it back on again. 4.
- Page 7 Solar lights and pumps work by using electricity generated by the solar panel to charge internal batteries. These batteries are then used to power the light and pump when there is no sunlight. When switched “ON”, the lights and pump are triggered. The duration of illumination and power will depend on the amount of sunlight and the charge received by the solar panels.
- Page 11 LED light cable Add approximately 5 gallons or 18.93 liters of water to the bottom basin.
Need help?
Do you have a question about the RJ-23063 and is the answer not in the manual?
Questions and answers