Table of Contents
Advertisement
Quick Links
Please read this booklet and keep for future reference
for the safe installation and operation of your
Stella ULEB
The Stella Woodfire can be installed on properties of less than 2 hectares of land and meets the
ECAN standards with emissions of 0.5g per kg of fuel burned and 65% efficiency tested under
AS/NZS 4012 and 4013:2014.
The Stella Woodfire also meets Canterbury Method v1.6 with emissions of 37mg per MJ of heat
output.
ULEB AUTHORISATION NUMBER 231103
LEB AUTHORISATION NUMBER 231104
This woodfire must be installed by someone competent to do so. Firenzo Woodfires recommend
the use of a NZ Home Heating Association, Solid Fuel Appliance Installation Technician (SFAIT),
or other suitably qualified person. The woodfire and flue system must be installed in accordance
with AS/NZS2918. All installations must be in accordance with these instructions. Consult with
the building authority having jurisdiction to determine the need for a permit prior to commencing
the installation. Failure to follow these instructions may also void your woodfire insurance and
warranty.
Stella ULEB Install Guide—December 2022
Advertisement
Table of Contents
Related Manuals for Firenzo Woodfires Stella ULEB
Summary of Contents for Firenzo Woodfires Stella ULEB
- Page 1 ULEB AUTHORISATION NUMBER 231103 LEB AUTHORISATION NUMBER 231104 This woodfire must be installed by someone competent to do so. Firenzo Woodfires recommend the use of a NZ Home Heating Association, Solid Fuel Appliance Installation Technician (SFAIT), or other suitably qualified person. The woodfire and flue system must be installed in accordance with AS/NZS2918.
- Page 2 Floor Protector Requirements Installation Clearances Assembly Instructions Flue Installation Instructions Operating Instructions Door Glass Maintenance Safety Warranties Under our policy of continuous product improvement, Firenzo Woodfires reserves the right to alter specifications or product from that shown. Stella ULEB Install Guide—December 2022...
- Page 3 Emission of poisonous gases can also be experienced with the burning of treated wood. Driftwood with salt content will also cause rapid deterioration of the woodfire and should not be used. Stella ULEB Install Guide—December 2022...
-
Page 4: Installation Responsibilities
The Stella Woodfire must be bolted to the subfloor beneath the ash hearth using the earthquake restraints at the back of the wood box. Stella ULEB Install Guide—December 2022... -
Page 5: Installation Clearances
Internal Firebox Measurements: Height 365m - Width 275mm - Depth 380mm All Clearances shown are from the EDGES OF THE CAST TOP of the Stella Woodfire CLEARANCES 200 265 595 1330 1080 Distance in MM Stella ULEB Install Guide—December 2022... - Page 6 1200mm high. This should be installed so that the bottom edge of the flue shield is 20mm from the top surface of the woodfire and spaced off the flue by approximately 35mm. Stella ULEB Install Guide—December 2022...
- Page 7 CAUTION: Mixing of fire or flue system components from different sources or modifying the dimensional specifications of components using more than one metre of extra flue may result in hazardous conditions. Where such action is considered the manufacturer should be consulted in the first instance. Stella ULEB Install Guide—December 2022...
- Page 8 1 metre above the roof penetration if more than 3 metres from the ridge. No part of the building, or any adjacent building may be in or above a circular area of a horizontal radius of 3 metres from the flue exit. Stella ULEB Install Guide—December 2022...
- Page 9 IMMEDIATELY SHUT THE FIRE TO ‘LOW’. Remember to close the air control gradually to your desired level of heat output. It is better to take 3-4 adjustments to get to the low setting (extended burn). Stella ULEB Install Guide—December 2022...
-
Page 10: Flammable Liquids
WARNING: DO NOT REMOVE EXCESS ASH FROM THE FIREBOX BY VACUUM UNLESS THE FIRE HAS BEEN OUT FOR 5 OR MORE DAYS - EMBERS WILL SMOULDER FOR SEVERAL DAYS AND WILL IGNITE VACUUM CLEANER BAGS. Stella ULEB Install Guide—December 2022... -
Page 11: Door Glass
Light lubrication is recommended once a year before the first autumn burn. Use a little GRAPHITE grease, available from any garage or engineering outlet. Take care not to over wind the nut on handle as this will strip the spindle thread. Stella ULEB Install Guide—December 2022... - Page 12 The flue should be cleaned regularly (at least annually prior to the winter) to avoid flue fires. In such an event, close the air control. Do NOT open door. Remove combustible items from near the woodfire and flue. Stella ULEB Install Guide—December 2022...
- Page 13 Guarantees Act 1993. To the fullest extent permitted at law, no other warranties or guarantees, express or implied, are assumed or given by Firenzo Woodfires to any person with respect to the quality, merchantability, description or fitness for purpose or use of Firenzo Woodfires or their component parts and materials.
- Page 14 A person is a designated accredited agent where they are identified and certified in writing by Firenzo Woodfires to be such with their authorities specified in the certificate. Consumers must take reasonable steps to satisfy themselves that they are dealing with designated accredited agents.
- Page 15 This document is intended to form part of (and may be expressly referenced in) the terms of sale and purchase by every original New Zealand consumer of a Firenzo Woodfire. For any questions about the warranties or this document please contact Firenzo Woodfires at its specified address, on telephone 06 8438260, by email at firenzo@firenzo.co.nz,...
- Page 16 Contessa Encore Lady Kitchener Napier Viking Vision Stella Topaz Insert Aqualux Bay Fire Flush Kompact Topaz 98 Niven Street PO Box 3231 HB Mail Centre Napier 4142 Phone: 06 843 8260 Website: www.firenzo.co.nz email: firenzo@firenzo.co.nz Stella ULEB Install Guide—December 2022...
Need help?
Do you have a question about the Stella ULEB and is the answer not in the manual?
Questions and answers