RCBS 87323 0224 Operating Instructions

PRECISIONEERED RELOADING EQUIPMENT
TECHNICAL SPECIFICATIONS
Measuring Range:
Resolution:
Accuracy:
Repeatability:
Display:
Power:
Working Temperature:
Storage Temperature:
Note:
PARTS GUIDE
2
4
1
OPERATING GUIDELINES
1. Caliper should be checked before each use to make sure that it is properly zero set. The reading should be zero when the external
jaws are closed, otherwise press 'ZERO' to set zero reading. Open and close the external jaws to verify if reading returns to zero.
2. One battery will last for one year of continuous use. If there is nothing on display or digits flash, battery voltage is too low. Please
replace battery (the positive side of battery should face out). If digits do not change when buttons are pressed or vernier is
moved, take out battery and put it back after 1 minute. Remove battery if caliper is not to be used for a long period of time.
3. Always apply constant force on thumb wheel during measurement and zero setting.
4. Tighten locking screw to hold reading.
5. Working temperature is 32-104°F. Do not put caliper near strong magnetic field. Keep caliper dry. Prevent liquid from getting into
caliper which may damage electronics. Do not apply voltage to the caliper such as engraving with an electric pen.
6. Measuring faces should be carefully protected from being scratched or damaged. Do not operate abruptly, drop or strike caliper.
0-150 mm / 0-6 in
0.01 mm / 0.0005 in
0.03 mm / 0.001 in
0.01 mm / 0.005 in
LCD Display
One Button Cell Battery 1.5V, Type SR44W or SR44
0º C to 40º C / 32º F to 104º F
-20º C to 70º C / -4º F to 158º F
Accuracy affected in environments exceeding 80% relative humidity
8 9 13 14
11 12 7
1
External measuring jaws
2 Internal measuring jaws
3 Depth Blade
4
Step Measuring Faces
5
Beam
Electronic Digital Caliper 0-6"
Operating Instructions
6
10
6
SAE Scale
7 Battery Compartment
8 LCD Display
9
Slider Clamp Screw
10
Thumb Roller
BASIC APPLICATION
1. Loosen the Locken Screw. The slider will not move unless this
step is done.
2. Press "On" button. Select SAE or Metric measurement by
pressing "mm/inch" button.
3. To reset display to zero, close external measuring jaws, then
press "Zero" button.
87323 0224
5 3
11
On/Off Switch
12 Zero Switch
13 SAE or Metric Units
14
Battery Compartment Screw