Search Band; Searching Modes - Yupiteru MVT-7100 Owner’s Guide Owner's Manual

See Delay in the Other Features section for further details.
Skip
The skip feature may be used during scanning to make sure the scan does not stay on any active
frequency more than 5 seconds.
See Skip in the Other Features section for further details.
Search Band Programming Mode
The MVT-7100 has 10 search bands (1-0) which are used to perform band searches. Before a band is used
to perform a search, it should be programmed with a starting and ending frequency as well as a step size
and receive mode to be used during the search.
To start this mode
1. Go to VFO mode
2. Select the receive mode and step size to be used
3. Press FUNC + BW
4. Enter the starting search frequency
5. Press ENT
6. Enter the ending search frequency
7. Press ENT
8. Press the number corresponding to the search band this data is to be programmed for
9. Two beeps will be heard confirming band programming

Searching Modes

The MVT-7100 offers two different ways to search for active frequencies.
The two modes are
VFO - This mode allows for a search to be started from the currently displayed VFO frequency.
Band - This mode allows a single specified band to be searched.
Changing Search Direction
All search modes start at the designated starting frequency and successively increment this frequency
using the current step size to try and find frequency activity. To reverse the direction of the search at any
time, simply turn the rotary control accordingly or press the appropriate arrow key.
Resume Searching
If the search stops on an active frequency that you do not wish to monitor, simply use the rotary control or
arrow keys to resume the search.
Cancelling Search
To cancel a search while it is running, simply press SRCH or MR.
The Two Search Modes
VFO
This mode is used to start a simple search from the VFO. Before starting the search, be sure the frequency,
step size and receive mode are set appropriately. To start this mode
1. Make sure the radio is in VFO mode
2. Press SRCH
3. The SEARCH indicator appears
Band
This mode is used to search one of the 10 specified bands.
To start this mode
1. Specify the band by pressing the appropriate digit key
2. Press SRCH