Yupiteru MVT-7100 Owner’s Guide Owner's Manual page 10

To start this mode
1. Press SCAN
2. The SCAN indicator appears
Continuous Mode
This mode is used to scan every programmed memory channel in every bank which has the specified
receive mode.
To start this mode
1. From VFO mode, select the desired receive mode
2. Press FUNC + M-SCAN
3. The SCAN indicator appears and receive mode blinks
Continuous Program
This mode is used to scan every programmed memory channel in every bank which has been specially
tagged with the program scan setting (PGM indicator).
To start this mode
1. Press FUNC + P-SCAN
2. The SCAN indicator appears and PGM blinks
Bank Normal
This mode is used to scan up to four specified banks from 1-0.
To start this mode
1. Specify up to four banks from 1-0 by pressing the appropriate digit keys.
2. Press SCAN
3. The SCAN indicator appears
NOTE : The selected banks are always scanned in numerical order (1-0) regardless of the order in which
they were entered.
Bank Mode
This mode is used to scan the channels of up to four specified banks from 1-0 which have the specified
receive mode.
To start this mode
1. Go to VFO mode
2. Specify up to four banks from 1-0 by pressing the appropriate digit keys
3. Select the desired receive mode
4. Press FUNC + M-SCAN
5. The SCAN indicator appears and receive mode blinks
NOTE : The selected banks are always scanned in numerical order (1-0) regardless of the order in which
they were entered.
Bank Program
This mode is used to scan every programmed memory channel which has been specially tagged with the
program scan setting (PGM indicator) from up to four specified banks from 1-0.
To start this mode
1. Specify up to four banks from 1-0 by pressing the appropriate digit keys.
2. Press FUNC + P-SCAN
3. The SCAN indicator appears and PGM blinks
NOTE : The selected banks are always scanned in numerical order
(1-0) regardless of the order in which they were entered.
Delay
The delay may be used during scanning to lengthen the scan resume delay time from 2 to 4 seconds.