2gig Technologies 2GIG-STZ-1 Quick Start Manual

Z-WAVE PLUS V2 THERMOSTAT QUICK START GUIDE
2GIG-STZ-1
Congratulations on your purchase of the 2GIG Thermostat. Its easy to install.
Lets get started.
1. Remove Existing Thermostat
TURN OFF POWER and remove the existing thermostat to expose the wiring terminals.
TAKE A PICTURE of the old thermostat wiring. This will allow reinstallation of the old thermostat if
necessary and help with troubleshooting.
TAKE A PICTURE!
W
Y
Existing Thermostat Terminals
2. Preparation for Installing Thermostat
Open the back panel as shown. Feed the wires from the wall through the access hole. Mount the back
panel to wall with anchors and Phillips screws (provided).
Use thumbs to grip and pull
to separate Back Panel
Body (with PCB)
Back Panel
3. Connect the Wires
Connect the wires to proper terminals based on your system setup (see instruction manual for details).
(Labeled Wires)
Y G R C
Y2 Y1 G RC RH C
Y2 Y1 G RC RH C
Copyright © 2020 Nortek Security & Control
LABEL THE WIRES TO MATCH
G R C
THE OLD THERMOSTAT TERMINAL
MARKINGS. LABELS NOT INCLUDED.
Anchors (2) Feed wires through access
Provided
Phillips Screws (2) Provided
W
Reference
Standard
W1 W2 W3 HUM- HUM+
Standard
Terminals
AUX/E O/B HUM- HUM+
4. Mounting the Thermostat to Wall
Mount the thermostat body/front panel onto the wall mounted base by pressing in place until it snaps
all around the edges.
Body/Front Panel
Back Panel
(Mounted to Wall)
Terminal Block
5. Install Batteries
If the thermostat is going to be battery operated, open front panel and install four (4) AA batteries into
the battery compartment.
NOTE: Please do not install batteries if powering through C wire.
Front Panel to Battery
Compartment
Back Panel/
Back Panel/Body
Body on Wall
(Attached to Wall)
Use Fingernails
at Indents on
top of the Case
Back Front Panel
Panel
Snap Together
Z-Wave QR Code
Front Panel
Back
Panel
Battery
Snap Together
Compartment
Front Panel