Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Akyga AK-EC-21
- Page 1 Wall EV Charger User Manual AK-EC-21 Power: 11kW Temperature Auto Efficient Protection High End Protection Repair Charging Level IP54 Short Circuit Earth Leakage Lightning Over Load Under Voltage Over Voltage Protection Protection Protection Protection Protection Protection www.akyga.com...
-
Page 2: Symbol Meaning
Symbol Meaning Meaning Symbol “Non-recyclable” mark: located on the product, instruction manual or package, indicating that electrical and electronic equipment and its accessories should be treated separately from ordinary household waste. When scrrapped, it should be treated as industrial waste, otherwise it may cause accidents Warning sign: indicates danger. -
Page 3: Product Overview
Product Overview Indicator light and RFID Charging plug Appearance of Wall AC Charger... - Page 4 Product Overview This product is a AC charging station, mainly used for AC charging of electric vehicles. The product is composed of charging station body, wall-hanging backboard, floor-to-ground column (optional), etc., with charging protection, charging by swiping card. This product adopts industrial design principle, easy to install and easy to use.
-
Page 5: Product Parameter
Product Parameter Rated Power 11kW User Interface Indicator light Cable routing Bottom inlet wiring, Bottom outlet wiring Charging model Card swipe / APP Dimension 290x180x95mm Charging Device Input voltage 3 phase; 380-440V Input frequency 50/60Hz Output voltage 380-440V Output current Charging Wire length Over-current protection value ≥110%... -
Page 6: Installation
Installation Fix the PLATE with SCREWS Assemble the ANTI-THEFT Place STATION onto on the wall SCREW from side PLATE on the wall Steps for Usage 1. Make sure the charging box 2. Connect the EV and the charging box 3.Use swipe card or APP to start. is connected power. - Page 7 Steps for Power Wiring (3 phase; 11kW) PLAN A If a power distribution box is used, the L1, L2, L3, N, and PE ends of the input cable of the plug correspond to the L1, L2, L3, N, and PE ends of the circuit breaker respectively.
-
Page 8: Warning And Cautions
Warning And Cautions For use only in the environment with RCD residual current protector; Do not use the device when the charging cable is damaged; For electric vehicle charging only; The product must be well grounded when used; It is strictly prohibited to step on the charging cable, pull the cable, bend or knot the cable. Do not put your finger into the charging plug. - Page 9 Common Trouble Handing Fault Reasons Suggestions 1. Disconnect the leakage/over current protection switch of the distribution box immediately. 2. Check whether the AC charger output line is damaged or has low impedance to the ground or short circuit. Excessive Excessive Leakage Leakage Current...
-
Page 10: What's In The Box
RFID card x 2 Hanging board x 1 Charging plug (opt) USER USER MANUAL MANUAL M3.5*35mm M3*10mm Rubber plugs + Side anti-theft User Manual x 1 Screws for hanging screws for hanging APP User Manual (opt) board x 4 board x 2 www.akyga.com...
Need help?
Do you have a question about the AK-EC-21 and is the answer not in the manual?
Questions and answers