Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Ideal Living AQUATru ATU100
Summary of Contents for Ideal Living AQUATru ATU100
- Page 1 UNDER SINK AquaTru 4-Stage Reverse Osmosis System ATU100...
-
Page 2: Table Of Contents
Under Sink / Instructions Table of Contents Safety Instructions Operational Parameters Before Installation Box Contents Installation Steps AquaTru 4-Stage Reverse Osmosis System Installation Steps Tubing Quick Connect Guide Cold Tap Water Adaptor Drain Saddle Installation RO Faucet Installation Installation of TruPure Holding Tank Sanitizer RO System Location and Mounting RO System Water Connection System Maintenance: Filters... -
Page 3: Safety Instructions
Under Sink / Instructions WARNING Please read and keep these instructions before proceeding with the installation. Safety Instructions • Installation needs to comply with state and local laws and regulations. • System must be installed indoors away from possible environmental damage. •... -
Page 4: Box Contents
Under Sink / Instructions Box Contents Filter manifold RO holding tank RO water faucet and 3 filters (PRE/Carbon Filter, RO Filter & VOC Filter) RO faucet quick Cold tap water adaptor Drain saddle for connect fitting with 3/8" adaptor and a waste water (with clear washer) 1/2"... -
Page 5: Aquatru 4-Stage Reverse Osmosis System Installation Steps
Under Sink / Instructions AquaTru 4-Stage Reverse Osmosis System Installation Steps Installation will be a breeze, since most of the parts are already assembled. We will guide you through the rest with the following steps: 1. How to use the quick connect fittings 2. -
Page 6: Cold Tap Water Adaptor
Under Sink / Instructions 2. Cold Tap Water Adaptor WARNING The water supply to the unit MUST be from the cold water line. Hot water will severely damage your RO system. Faucet connector Locate the cold water valve underneath the sink, and hose turn it off. - Page 7 Under Sink / Instructions 2. Cold Tap Water Adaptor Before mounting onto the tap water line, connect the white tubing to the end of the adaptor and then install the adaptor. The AquaTru Under Sink RO system comes with comes with a 3/8" adaptor that has a 1/2"...
-
Page 8: Drain Saddle Installation
Under Sink / Instructions 3. Drain Saddle Installation Caution To avoid possible drainage noise, mount the drain saddle as low as possible onto the vertical tailpiece. The drain saddle assembly should be installed above the trap and on the vertical or horizontal tailpiece. RO faucet Mount drain saddle here... - Page 9 Under Sink / Instructions 3. Drain Saddle Installation Mark the position of the hole on the drain pipe and drill a 1/4" hole through one side of the drain pipe. There is a piece of self-adhesive sponge provided. Glue this sponge to the inside of the saddle, this will cushion any gap between the saddle and the pipe.
-
Page 10: Faucet Installation
Under Sink / Instructions 4. RO Faucet Installation The RO faucet may be installed on any flat surface. Check the underside of your install location for interference by making sure that drilling a hole will not damage any pipes or wiring underneath the countertop of the sink. -
Page 11: Installation Of Trupure Holding Tank Sanitizer
Under Sink / Instructions 5. Installation of TruPure Holding Tank Sanitizer Unscrew the blue cap from the RO holding tank. 2. Wrap the plumber’s tape around on the stainless steel threaded stem of the RO holding tank. 3. Screw the TruPure holding tank sanitizer onto the holding tank, hand tighten. 4. -
Page 12: System Location And Mounting
Under Sink / Instructions 6. RO System Location and Mounting Install the three filters into the filter manifold in accordance to the filter color code. Locate the area under your sink where you want to install the RO system, (RO manifold with filters and RO holding tank). Note: The filter manifold can be mounted on a cabinet wall. - Page 13 Under Sink / Instructions...
-
Page 14: System Maintenance: Filters
Under Sink / Instructions 8. System Maintenance: Filters Turn on the tap water: Slowly turn on your cold water supply, then open the tap water adaptor valve, (turn counterclockwise) to allow untreated water to enter the system. CHECK FOR LEAKS! Open RO holding tank valve: Open the tank’s ball valve to allow water to enter the tank. -
Page 15: System Maintenance
Under Sink / Maintenance 9. System Maintenance Filter Change: The RO system contains three filters that must be replaced at regular intervals to maintain performance. Use only genuine AquaTru filters. The three filters are: · · Pre-Filter (AT2001) should be replaced every 6 months or every 600 gallons, whichever comes first. VOC Filter (ATU2003) is replaced every 12 months or every 360 gallons, whichever comes first. - Page 16 Under Sink / Maintenance 9. System Maintenance: Sanitizing the RO Holding Tank Sanitize RO holding tank: The RO system should be sanitized once a year. We recommend that you do the sanitizing process each time you replace the VOC filter, every 12 months. You should complete the sanitizing process before you replace the VOC filter.
-
Page 17: Faq & Troubleshooting
Under Sink / Maintenance FAQ & Troubleshooting PROBLEM CAUSE SOLUTION Low / slow Low water pressure Make sure the water supply is turned on and the production valve is all the way open. Tap water pressure should be at a minimum of It takes longer 40 PSI. -
Page 18: Warranty
Under Sink / Maintenance FAQ & Troubleshooting PROBLEM CAUSE SOLUTION Leaks from filter Filter not fully installed, or O-ring is damaged Check that the filter is fully installed. manifold Depressurize the filters by turning off the tap water supply line and then turning off the RO holding tank valve.”... -
Page 19: Filter Replacement Records
Under Sink / Filter Records Filter Replacement Records | Pre/Carbon Filter | RO Filter | VOC Filter Date: Date: Date: Date: Date: Date: Date: Date: Date: Date: Date: Date: Date: Date: Date: Date: Date: Date: Date: Date: Date: Date: Date: Date: Date: Date:... - Page 20 AquaTru.com ©2022 AquaTru, LLC. All Rights Reserved. 02.22.R8...