aebi schmidt Meyer 17199 Parts & Installation Instructions

End user must be given this instruction sheet prior to delivery of Snow Plow.
In conjunction with FMVSS (Federal Motor Vehicle Safety Standards) and OEM (Original Equipment Manufacturer) guidelines,
Meyer Products has designed this plow package with the following guidelines:
Installation of a snowplow may effect your new vehicle warranty.
For more information consult your Vehicle Owner's Manual / Vehicle Dealer.
The vehicle must not be operated when overloaded. In all cases, the loaded vehicle weight, including the entire snowplow
system, all aftermarket accessories, driver, passenger, options, nominal fluid levels, and cargo must not exceed the
front/rear Gross Axle Weight Rating (GAWR), and total Gross Vehicle Weight Rating (GVWR). These weights ratings are
specified on the safety compliance certification label on the driver's side door opening. The use of rear ballast weight
may be required to prevent exceeding the front GAWR.
According to the NHTSA (National Highway Traffic Safety Administration) new and untitled vehicles need to be verified by the installer that
snowplow and ballast (if needed) do no exceed the front/rear GAWR and total GVWR.
Read the Meyer Owner's Manual before operating or servicing a snowplow.
EXPLICITLY.
SAFETY PRECAUTIONS should be used when Hydraulic Unit is in OPERATION and plow is in a RAISED position.
Lower plow to ground when vehicle is PARKED in case of hydraulic failure.
Check contents against the parts list to determine all are correct and included, and also to familiarize yourself with them.
Warranty does not apply to a Meyer product which has been negligently or improperly assembled or installed.
CAUTION: To avoid harm to vehicles electrical system always disconnect battery before beginning installation. DO NOT BURN
holes or WELD vehicle frame. This may cause frame failure.
Meyer Products reserves the right, under its continuing product improvement program, to change construction or design details, specifications and prices
without notice or without incurring any obligation.
© 2019 Printed in the U.S.A.
PARTS & INSTALLATION INSTRUCTIONS
MDII™and EZ MOUNT PLUS™
SNOW PLOW MOUNTING 17199
2019 & LATER GMC 4500/5500 4 X 4
SAFETY DEFINITIONS
This is the safety alert symbol. It is used to alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol to avoid possible injury or death.
DANGER Indicates an imminently hazardous situation which, if not avoided, will result in
death or serious injury.
WARNING Indicates a potentially hazardous situation which, if not avoided, could result
in death or serious injury.
CAUTION Indicates an potentially hazardous situation which, if not avoided, may result in
minor or moderate injury.
CAUTION used without the safety alert symbol indicates a potentially hazardous situation
which, if not avoided, will result in property damage.
IMPORTANT NOTICE
GENERAL INFORMATION
OVERHAUL and SERVICE INFORMATION are covered on separate instructions.
18513 Euclid Ave. • Cleveland, Ohio 44112-1084
Meyer Products Inc.
Phone (216) 486-1313
Form 1-1191R
October 2020
FOLLOW THESE INSTRUCTIONS
www.meyerproducts.com