Download Print this page

Weather Fast 103-0606 Assembly Manual

Fabric storage shed

Advertisement

Quick Links

TM
Fabric Storage Shed
6'x 6'x 6'(1.8x1.8x1.8m)
ASSEMBLYMANUAL
Model NO.:103-0606
Tools required for assembly (not included)

Advertisement

loading
Need help?

Need help?

Do you have a question about the 103-0606 and is the answer not in the manual?

Questions and answers

Summary of Contents for Weather Fast 103-0606

  • Page 1 Fabric Storage Shed 6'x 6'x 6'(1.8x1.8x1.8m) ASSEMBLYMANUAL Model NO.:103-0606 Tools required for assembly (not included)
  • Page 2 TABLE OF CONTENTS Important safety instructions ...........................................2 Intended use ..............................................2 Parts list .................................................3 Assembly preparation .............................................4 Assembly ..............................................4 - 8 IMPORTANT SAFETY INSTRUCTIONS WARNING! To reduce the risk of serious injury, read the following safety instructions before assembling and using the product. No responsibility is accepted for damages or injuries resulting from improper installation or noncompliance with these instructions.
  • Page 3 PARTS LIST Description Illustration Rafter Pole Extension Pole with Dimples Common Tube-male union Cross Rail-male union Cross Rail with punched hole Bent Corner Leg 3-Way Peak Connector 3-Way Side Connector-left 3-Way Side Connector-right 3-Way Cross Rail Clamp Ratchet Tie Down M6 Nut M6X40 Bolt M6 Washer...
  • Page 4 ASSEMBLY PREPARATION Place all parts from the packaging box in a cleared area and arrange them on the ground in front of you. Remove all packaging materials and place them back in the box. Do not dispose of the packaging materials until assembly is complete. Check for completeness and transport damages.
  • Page 5 ASSEMBLY Step 1: Assembling roof frame Step 2: Attaching legs ● Assemble the legs (fig. 5). Lay out the roof frame parts as shown below (fig. 1). Leg type Connect to Extension pole with dimple (2), Corner legs Bent corner leg (6), Insert the corner legs into the 3-way side connectors(8) (9) (fig.
  • Page 6 ASSEMBLY Step 4: Anchoring frame To make sure the strap will stay in the sleeve when assembly Thread the strap through the spindle of the ratchet (fig. 13). CAUTION! The shed must be well-anchored. Do not attempt to install any of the fabric before the frame is properly anchored.
  • Page 7 ASSEMBLY Stretch the roof tarp (15) over the shed frame and make sure it is centered on the frame (fig. 20). Use a ladder if necessary. Attach the other two corners of the front door panel(17) to the 3-way side connectors(8,9) in the same way (fig.17). Tube sleeve Cross rail-male union (4) Cross rail with punched hole (5)
  • Page 8 ASSEMBLY Caution! ● Tight the string for the bag seal(fig. 23). Check and tighten the bottom cross rail connectors(4)(5) and ratchets (11) monthly to ensure that the roof tarp (15) is tight and safe. When disassembling the shed, press the spring-loaded bar and open the ratchet handle completely to pull out the strap (fig.