Disposal - Bosch PKM975DK1D User Manual And Installation Instructions

WARNING ‒ Risk of burns!
The hotplate heats up but the display does not work.
Switch off the fuse in the fuse box.
▶
Call the customer service.
▶
16.1 Information on display panel
Fault
None
All displays flash
and the heat set-
ting flash alternately.
A signal sounds.
and audible signal Hot pot near the control panel. The hotplate has been switched off to protect the electron-
and hotplates do
not heat up
A message with "E"
appears on the dis-
play, e.g. E0111.

Disposal

17 Disposal
D o p s a l - i s
17.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
Dispose of the appliance in an environmentally
▶
friendly manner.
Cause and troubleshooting
There has been a power cut.
Check the household fuse for the appliance.
1.
Check whether there has been a power failure by trying other electrical appliances.
2.
The control panel is wet or objects are lying on it.
Dry the control panel or remove the object.
▶
Several hotplates have been used over a prolonged period at high power settings. The hot-
plate has been switched off to protect the electronics.
Wait a while.
1.
Touch any touch field.
2.
a When the message no longer appears, the electronics have cooled down sufficiently.
You can continue to cook.
Despite being switched off by
therefore been switched off.
Wait a while.
1.
Touch any touch field.
2.
a When the message no longer appears, the electronics have cooled down sufficiently.
You can continue to cook.
Hot pot near the control panel. There is a risk that the electronics will overheat.
Remove the pan.
▶
a The display goes out shortly afterwards.
ics.
Remove the pot.
1.
Wait a while.
2.
Touch any touch field.
3.
a When the message no longer appears, the electronics have cooled down sufficiently.
You can continue to cook.
The hotplate was on for too long and has switched off automatically.
You can switch the hotplate back on again immediately.
Demo mode is activated.
Disconnect the appliance from the power supply for 30 seconds by briefly switching off
1.
the circuit breaker in the fuse box.
Touch any touch field within the next three minutes.
2.
The electronics have detected a fault.
Switch the appliance off and on again.
1.
a If the fault was a one-off, the message disappears.
If the message appears again, call the after-sales service. Please specify the exact error
2.
message when calling.
→ "Customer Service", Page 16
WARNING ‒ Risk of fire!
The hob switches off automatically and can no longer
be operated. It may switch on unintentionally at a later
point.
Switch off the fuse in the fuse box.
▶
Call the customer service.
▶
, the electronics have become hot again. All hotplates have
Information about current disposal methods are
available from your specialist dealer or local author-
ity.
Disposal en
15