Advertisement
Quick Links
Programming and Set up for the New LDP 9208D/9224D/F & 9240D.
The EHSA looks like below with the EHS on the bracket.
IMPORTANT: THE PHONE NEEDS TO BE TURNED OFF
FROM POWER BEFORE PLUGGING THE EHS CABLE IN
Step 1 – plugging the flat cable (attached to the bracket EHS) this is a grey cable
with a pink strip on it) into the dss port on the back of the phone with the pink strip
facing upwards. (as the diagram below)
Advertisement
Summary of Contents for Simply Headsets LDP 9208D
- Page 1 Programming and Set up for the New LDP 9208D/9224D/F & 9240D. The EHSA looks like below with the EHS on the bracket. IMPORTANT: THE PHONE NEEDS TO BE TURNED OFF FROM POWER BEFORE PLUGGING THE EHS CABLE IN Step 1 – plugging the flat cable (attached to the bracket EHS) this is a grey cable with a pink strip on it) into the dss port on the back of the phone with the pink strip facing upwards.
- Page 2 Step 2 – Now with the Rj square telephone plug to Rj short cable connection cable one end plugs into the black EHS box just in this RJ style port, the other plugs into AUX port on the back of the Jabra as circled in the diagram. *Please note the back will look slightly different depending on the model of Jabra purchased but the ports are the same.
- Page 3 Step 3 – The cable that comes in the box with the headset – needs to be plugged into the Blue port (labelled Telephone port in the photo) on the base of the Jabra as circled below and then into the headset port on the phone – this port should have a little picture of a headset above it.
- Page 4 3. . Press the Transfer (Trans) Key and then the numbers 62 and select 3 for Both - press Hold to save. This will allow the sound to come through phone and headset. Now we are nearly done! The last part , You will then need to program the headset to tell it which EHS you are using.
- Page 5 6. When finished, center-press the microphone volume switch to save settings and exit setup mode. The base will restart. If you are using a Jabra pro 9460/9470/Motion office; follow these instructions: With the headset sitting on the base please press the spanner in the top right corner. use the arrow to scroll down to phone settings then click that.
- Page 6 You will need to access the voice-guided menu as per above, use the call button to toggle through the different options until you hear Hook Lifter type. Once you hear this use the volume up/down buttons to cycle through the options till you hear DHSG.
Need help?
Do you have a question about the LDP 9208D and is the answer not in the manual?
Questions and answers