Cleaning And Care; Emptying The Fluff Collector; Cleaning The Housing And Cutting Head - Silvercrest 449407 2307 Operating Instructions Manual

Cleaning and care

Emptying the fluff collector
1) Pull the fluff collector 3 down in the direction of the
arrow and then lift it off.
2) Empty out the textile fluff.
3) Replace the fluff collector 3 so that it is firmly in
place.

Cleaning the housing and cutting head

WARNING! RISK OF INJURY! Be careful when
handling the blades under the shaver foil 4. These
are very sharp and can easily be damaged.
ATTENTION! Do not use abrasive, aggressive or chem-
ical cleaning agents. These could damage the surface
of the appliance!
Clean the housing, the removed spacer 5 with a
♦
moist cloth.
Unscrew the shaver foil 4 from the appliance. Clean
♦
the shaver foil 4 with a slightly damp cloth.
♦ Brush fluff and lint remnants from the cutter knives with
the cleaning brush 6.
When all parts are well dried, screw the shaver foil 4
♦
back on.
Replace the spacer 5 so that it is seated firmly.
♦
SFR 3 A1
GB │ MT │
47 ■