Advertisement
Quick Links
CALIFORNIA PROPOSITION 65 WARNING
WARNING: This product can expose you to chemicals including Chromium (hexavalaent compounds), which are
known to the State of California to cause cancer and birth defects or other reproductive harm. For more
Do not use power tools to assemble. Only use hand tools, as power tools can
• Unpack and lay out all of the included parts. Most of the stainless steel pieces come with a protective film. Remome
all of the plastic film and pay no attention to the print on the film as it has nothing to do with the assembly
instructions.
• Take caution with the stainless steel components as to not scratch them during the assembly process. Use a non-
aggressive surface and protect the stainless steel as best as possible.
• 5 mm screw will be paired with a 5mm lock washer. Use a flat washer and lock washer for installing the casters to
the base. All other connections will be made with a screws only.
• NOTE: screws for the door handles are smaller and those are packaged with the handles them self.
• 5 mm are to used last and are for securing panels to cart.
information go to: www.p65Warnings.ca.gov
damage or loosen the nutsert.
Tools Needed: #2 Phillips Head Screw
M5 x 12 mm
Before getting started:
Page 1
BLAZE KAMADO CART ASSEMBLY
Driver – "Not Included"
M5 x 24 mm
M5 washer
M5 lock
washer
Advertisement
Related Manuals for Blaze KAMADO CART
Summary of Contents for Blaze KAMADO CART
- Page 1 BLAZE KAMADO CART ASSEMBLY CALIFORNIA PROPOSITION 65 WARNING WARNING: This product can expose you to chemicals including Chromium (hexavalaent compounds), which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to: www.p65Warnings.ca.gov...
- Page 2 1. Bottom Cart Panel- flip the panel upside down on a protected surface exposing the four locations where the casters attach. There are two runners on the bottom cart panel bottom with 4 nutserts (female threaded inserts which a screw goes into) on each end of each runner.
- Page 3 Attach Bottom Back Panel - The bottom back panel first gets secured to the Bottom Cart Panel with 2 screws. (The bottom of the panel has openings for screws to go through, see diagram). Attach but to not tighten. Next secure the Bottom Back Panel to the right and left side panels.
- Page 4 Attach soft close hinge - please follow below instructions Side adjustment Height adjustment Depth adjustment Rotate front screw to increase or decrease Rotate cam screw on mounting plate to Rotate rear spiral tech cam screw to adjust door overlay (±2 mm). adjust door position (±2 mm).
- Page 5 At this point cart should be fully tightened and doors should be attached and aligned. See below images. Using two people carefully grab kamado by the front lower ash hole and rear hinge bracket and lift onto the cart. First add kamado feet onto cart surface, then with two people lift and center kamado on cart. Page 5...
- Page 6 Attach the front kamado support - slide panel into place and align with nut-cert holes. . At this point, all 4 screws from the this step can be completely tightened. Attach the upper kamado support ring - slide panel into place by lifting it up and over the top of the kamado, align with nut-cert holes and tighten.
- Page 7 Attach Side Shelves and front storage shelf - Four screws per shelf are used to attach to the right and left side panels. Both shelves are exactly the same and can be used on either side. Start all 4 screws into the side panel as the shelf can then simply be placed over the screws and pushed downward in place.
Need help?
Do you have a question about the KAMADO CART and is the answer not in the manual?
Questions and answers