Acuity Brands Lighting ISCG Series Installation Manual

ISCG Connected Gateway for STAR Enclosure
Installation Guide
SAVE THESE INSTRUCTIONS AND DELIVER TO OWNER AFTER INSTALLATION
!
All service must be performed by qualified service personnel.
!
When using electrical equipment, basic safety precautions should always be
followed, including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
CAUTION — All service must be performed by qualified service personnel.
CAUTION — Read and follow all safety instructions.
CAUTION — Remove internal assembly prior to drilling and/or punching additional or larger holes for
WARNING — When using electrical equipment, follow basic safety precautions, including the following:
The severity of the hazards associated with this product are identified in accordance with ANSI Z535.4.
!
Remove internal assembly prior to drilling and/or punching additional or larger holes for conduits, and
remove excess metal shaving and contaminants prior to powering the panel.
Acuity Brands assumes no responsibility for claims arising out of improper use or careless installation or handling of this product.
For a complete list of product Terms and Conditions, please visit www.acuitybrands.com.
Acuity Brands | One Lithonia Way, Conyers, GA 30012 | Phone: 800.535.2465 | www.acuitybrands.com | © 2023 Acuity Brands Lighting, Inc.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS!
IMPORTANT SAFETY INSTRUCTIONS
conduits, and remove excess metal shavings and contaminants prior to powering the panel.
Do not use outdoors.
Do not mount near gas or electric heaters.
Do not mount equipment in locations and at heights where it cannot be accessed or
tampered with by unauthorized personnel.
Do not use accessory equipment not recommended by the manufacturer. To do so may
cause unsafe conditions.
Only use for intended purpose.
Failure to follow any of these instructions could void product warranty.
Always read complete installation instructions prior to installation!
SAVE THESE INSTRUCTIONS