Advertisement
OPERATING INSTRUCTIONS
Prior to turning on the unit, set each selector, switch and control as below:
• SPEAKERS- -► OFF, A, B or A+B
• BASS, TREBLE - -- 0
• BALANCE - -- 0
• TONE - -ON
• FILTER - -- OFF
• ATTENUATOR - -- 0
• VOLUME-
-
►
— oo
• TAPE - -- SOURCE
• LOUDNESS - -- OFF
• MODE SELECTOR - -- STEREO
FM AND AM RECEPTION
1.
Set the INPUT SELECTOR switch to TUNER.
2.
Operate the tuner.
3.
Adjust the volume and the tonality.
TURNTABLE OPERATION
1.
Set the INPUT SELECTOR switch to PHONO.
2.
Operate the turntable.
3.
Adjust the volume and the tonality.
AUX JACKS UTILIZATION
1.
Set the INPUT SELECTOR switch to AUX.
2.
Operate the component connected.
3.
Adjust the volume and the tonality.
TAPE DECK OPERATION
PLAYBACK
1.
Set the TAPE switch to TAPE A or TAPE B
in accordance with the tape deck to be operat¬
ed.
The INPUT SELECTOR switch can be
in any position.
2.
Operate the tape deck.
3.
Adjust the volume and the tonality.
TAPE MONITORING
If you use the unit with 3-head type tape
decks, you can check the sound quality of the
recording by momentarily comparing the recorded
sound with the source sound as follows:
• Set the TAPE switch to TAPE A or TAPE B to
monitor the recorded sound.
• Set the TAPE switch to SOURCE to monitor
the source sound before recorded.
WHEN RECORDING WITH ONE TAPE DECK
1.
Set the INPUT SELECTOR switch to the
desired program source.
2.
Set the selected program source in operation.
3.
Operate the tape deck. Recording level should
be adjusted with its volume control.
Note:
Recording is not affected by the unit's controls and
switches such as BASS, TREBLE, BALANCE, TONE,
FILTER,
ATTENUATOR, VOLUME and
LOUD¬
NESS.
WHEN RECORDING WITH TWO TAPE DECKS
1.
Set the INPUT SELECTOR switch to the
desired program source.
2.
Set the selected program source in operation.
3.
Operate two tape decks.
Recording levels
should be adjusted with their volume controls.
To monitor the recording, set the TAPE switch
to TAPE B.
It is impossible to monitor the
recording in the tape deck A when recording
with two tape decks.
Note:
When recording with two tape decks, a source signal
cannot
be
recorded
in
the tape deck
B
if the
TAPE switch is set to TAPE A.
Therefore, be sure
to set the TAPE switch to SOURCE or TAPE B only.
10
KA-7100(K)
Advertisement
