Rondish TM-EAP-01 Quick Start Manual

Rondish Company Limited
Early Alert
Bed Sensor Pad
TM-EAP-01
For Safety, Replace This Pad
After 18-Month of Use
CAUTION: Technology alone cannot prevent
falls of injury. This device must supplement a
facility's fall management and supervisory
program.
Sensor Pad Instructions
Select Pad Setting:
1. Open the pocket to access the 3-way switch on the
transmitter module. The default position of OFF.
2. "TX-only" will activate Early-Alert function only on
the transmitter side of the sensor pad. Alarm goes
off when a patient is sitting on the "TX" side edge of
the sensor pad and about to leave their bed. The
other side remains in a normal setting. The alarm
goes off when the patient leaves their bed.
"Both-sides" will enable Early-Alert function on both
sides of the sensor pad.
Pad with Monitor:
1. Press the "Program" button on the wireless monitor
unit – you will hear a beeping from the monitor.
2. Press and release the centre zone of sensor pad to
add it into memory. You will see visual and audible
feedback from the monitor to confirm the signal
was received.
3. Test the sensor pad by pressing and releasing.
Secure the Pad:
1. Position the sensor pad across the bed beneath
the hips of the patient. The neck of the sensor
pad should exit out the side of the bed.
2. Optional clip sets are available to prevent pad
movement. They loop through the eyelets as
shown below.
3. They can be clipped to the bed to hold the
sensor pad in place.
Care & Maintenance Instructions:
 Use disinfectant wipes or antibacterial cleansers
to clean the pad.
 DO NOT immerse the sensor pad in any liquid.
 DO NOT expose the sensor pad to high
temperature sanitizers.