Related Manuals for Rasonic RG-H261(LP)
Summary of Contents for Rasonic RG-H261(LP)
- Page 1 Domestic Gas Hob Operating/Installation Manual RG-H261(LP) MODEL RG-H361(LP) NUMBER RG-H261(TG) RG-H361(TG) Please read this manual carefully before using this appliance...
-
Page 3: Table Of Contents
Dear customer, • Thank you for selecting this Rasonic product. • The safety precautions and recommendations provided in the manual are for your own safety. Please keep this booklet for future reference relating to the operation and maintenance of the gas hobs. -
Page 4: Important Safety Precautions And Recommendations
1. Important safety precautions and recommendations a. Unpack the gas hob from the carton box and inspect for physical damage. In case of doubt, do not install / operate the gas hob and contact your supplier for professional advice. b. Never attempt to modify the gas hob. c. -
Page 5: Models And Parts Of Gas Hob
2. Models and parts of gas Hob A:Main burner (oxygen-enriched burner) B:Auxiliary burner C:Burner control knob Fig.1 RG-H261(LP) RG-H261(TG) RG-H361(LP) RG-H361(TG) A:Main burner (oxygen-enriched burner) B:Auxiliary burner Fig.2 3: Ignition electrode 1: Outer ring cap 2: Principe burner cup 6: Auxiliary burner ring 4: Thermocouple 5: Venturi 7: Auxiliary burner cup... -
Page 6: Product Technical Parameters
3. Product technical parameters Product Model RG-H261(LP) RG-H261(TG) RG-H361(LP) RG-H361(TG) Type Of Gas Rated Pressure (Pa) 2900 1500 2900 1500 Rated Power (kW) L 4.5 R 4.5 L4.5 M1.0 R 4.5 Products Size (mm) 780×460×150 860×480×150 Built-in Size (mm) W(650-730) × D(350-410) × R20 W(700-804) ×... -
Page 7: Installations Instructions
5. Installations instructions 5.1) IMPORTANT • The appliance should be installed, regulated and adapted to function with other types of gas by a QUALIFIED INSTALLATION TECHNICIAN. Failure to comply with this condition will render the guarantee invalid. • The appliances must be installed in compliance with regulations in force in your country and in observation of the manufacturer’s instructions. - Page 8 5.3) CUT-OUT DIMENSION & REPLACEMENT SIZE Please be ensure to use the correct dimensions as shown below for installation. Model Cut Out Dimension(mm) Replacement size(mm) Height(mm) RG-H261(LP) W650×D350 FA60×FB60 W(650-730)×D(350-410) × R20 RG-H261(TG) RG-H361(LP) W700×D400 FA50×FB50 W(700-804)×D(400-430) × R20 RG-H361(TG) RG-H261(LP) RG-H361(LP) RG-H261(TG)
- Page 9 5.4) INSTALLATION OF GAS HOB IN KITCHEN CABINET WITH DOOR The cabinet has to be made in accordance to specific requirements to ensure proper operation of the gas burners when the flame is turned down to minimum, pressure change while opening and closing the cabinet doors. The cabinet should have openings to facilitate ventilation (see Fig.5 &...
- Page 10 5.8) Inlet gas connection IMPORTANT: • The appliance should be installed, regulated by a QUALIFIED INSTALLATION TECHNICIAN. • The appliance is fitted with specified gas type as shown in the specification nameplate and cannot be used or converted to any other type of gas. INSTALLING THE COOKER Gas Connection to the appliance Appliance installation work must be carried out by professional contractor accepted by...
- Page 11 INSTALLING THE COOKER Gas Connection to the appliance Hong Kong Town Gas Connection: Use appropriate piping and accessories for connection. In Hong Kong, The following connection methods shall be used. a. Stainless steel braided flexible tubing connection: Use approved gas tubing bearing EMSD approval marking(such as: 機電工程署批准EMSD APPROVALGTXXXX) for connection to appliances, or other appropriate methods accepted by EMSD.
-
Page 12: Using Instructions
6. Using Instructions 6.1) Installing the battery • Insert a DC1.5V battery into the battery compartment (see below fig.8) in the cover. This battery is the power supply for the electronic ignition of gas burners. Only use a DC1.5Volt battery (size “D”). Check for correct polarity (label to the side of the battery compartment). - Page 13 6.3) Fire regulation By adjusting the control knob to the corresponding position below, you can control the flow of gas into the burner and adjust the power of the flame. (See table below) OFF (close valve) High (maximum aperture or flow) Low (minimum aperture or flow) The size of flame depends on the position of the related burner control knob(Fig.9).
- Page 14 6.5) Selection of burners and diameters of pan On the control panel, near each knob, the corresponding control burner is marked. Select the burner in according to the diameter of the pan used and the heat input. The recommended burners for the flat bottom pan diameters are as follow: Type of burners Pan diameter (cm)
-
Page 15: Cleaning And Maintenance
7. Cleaning and maintenance Special care should be taken around the underneath of the appliance as this area is not designed or intended to be touched and may contain sharp or rough edges, that may cause injury. For safety, always wear a pair of rubber gloves while cleaning. Cleaning and maintenance should be carried out after the appliance has turned cold especially when cleaning burner and the cast iron support. - Page 16 After cleaning the burners and the caps must be well dried and put back correctly. Check that the burner elements are positioned correctly (Fig.13). Failure to do so can cause serious problem. As indicated by the arrow, the positioning boss (A) of the burner assembly must be placed on the corresponding groove (B) of the burner head, so that the ignition needle electrode (C) is facing the ignition end (D) of the burner .It will not rotate if placed correctly.
-
Page 17: Identify And Deal With Common Faults
8. Identify and deal with common faults Fault phenomenon Fault reason Processing method The battery is loose or the Install or replace battery is installed backwards the battery properly No spark or weak or the battery is dead spark at ignition electrode Burner assembly not installed Install the burner... -
Page 18: Customer Service
9. Customer service If the gas cooking stove is abnormal, please stop using it and contact the local after-sales service center of the company. Warning: Only professionally trained and qualified gas range maintenance personnel are allowed to repair the gas range. Other personnel shall not repair the gas stove without authorization, so as to avoid serious consequences.