Timer Recording/Playback - Denon DRS-810 Service Manual

TIMER RECORDING/PLAYBACK
Amplifier
Stereo cassette deck
ra
i Wall outlet
| On timer recording /playoack
HT
J
1
{
4 .
! Timer
1
'
i}
i]
1
@Timer recording procedure
1. Make sure
the connections are
correct, especially
the
power supply connections.
2. Turn ''on" the power switch of each appliance.
3. Tune the desired station on the tuner.
4. toad the tape for recording. (Make sure the erase
prevention tab is not broken off; if it is, cover the
hole with plastic tape).
6. Make sure the monitor switch to the SOURCE position.
7. Adjust the recording input level.
8. Set the starting position of the tape.
9. Set the timer switch (TIMER) to the ''rec'' side.
10. Set the audio timer to the desired time. The audio timer
will turn the power supply on at the desired time.
Speaker System
@Timer playback procedure
1. Make sure the connections are correct, especially the
power supply connections.
Turn ''on'' the power switch of each appliance.
Load the pre-recorded tape to be played back.
Set the Dolby NR switches to the appropriate positions.
Set the monitor switch of the Amplifer to the TAPE (Ml)
position.
Press the PLAY (>) button and playback the tape; adjust
the playback level.
Set the timer switch (TIMER) to the ''play'"' side.
Set the audio timer to the desired time. The audio timer
will turn the power supply on at the desired time.
*With the above procedures, timer playback can be ac-
complished. When the preset time comes, the power is
supplied and playback will start.
Note:
-Please read the operating instructions for the timer
before use.
+ lf the timer recording or playback is not desired, be sure
to switch the timer switch (TIMER) to "'off''.
- When using timers that allow several ''on/off'' operations,
timer start functioning can continue an unlimited number
of times until the tape in the machine is finished.
CGN
AnD
DRS-810
11