Subscribe to Our Youtube Channel
Summary of Contents for GLI PROTECT-A-POOL 4300501
- Page 1 ® NGROUND EMOVABLE AFETY ENCE N S T A L L A T I O N N S T R U C T I O N S GLI P • 215 S • Y , OH 44510 RODUCTS INTER OURT OUNGSTOWN •...
-
Page 2: Table Of Contents
NSTALLATION OOLS ABLE OF ONTENTS The following tools are required for installation. Fence Components..............5 Getting Started................6 Chalk Pencil Marking the Holes..............7 Utility Knife Tape Measure Planning for the Gate..............8 Template (included) Post Angles................10 Power Drill Rope - (need enough to outline the fence layout) Warning..................17 Scissors Power Screw Driver... -
Page 3: Fence Components
ARNING ENCE OMPONENTS HERE IS NO SUBSTITUTE FOR COMPETENT ADULT SUPERVI EMPLATE SION IN THE SWIMMING POOL ENVIRONMENT IVES DEPEND ON YOU LWAYS KEEP THE GATE CLOSED AND FENCE PANELS FASTENED ECTION OF ENCE K K I ALWAYS T IS RECOMMENDED TO WATCH CHILDREN AT ALL TIMES K K T HE USE OF THIS FENCE CAN HELP REDUCE THE UNAUTHORIZED... -
Page 4: Getting Started
LEASE READ THROUGH THE ENTIRE 2. Determine the starting point of the fence along your proposed fence line. INSTRUCTION MANUAL BEFORE YOU BEGIN THE INSTALLATION 3. Mark the holes for drilling using the template provided with the safety fence, or use a tape measure to mark holes for fence posts. -
Page 5: Planning For The Gate
4. Drill holes for the fence posts. LANNING THE If you intend on installing the gate, It is recommended to drill a pilot hole with a 1/4” bit first, then you must consider the following finish the hole with a 5/8” bit. measurements. -
Page 6: Post Angles
90 Degree Corners NGLES 90 degree corners should use two CONTINUED panels for maximum strength and Straight Runs stability. Posts for straight runs of fence should be angled at 1/2 degree with the top angled away from the pool. This can be done by placing two panels at a right angle and angling the posts away from each other at 5 degrees. - Page 7 Repeat steps 3 through 6 up to the location where Drill holes for left and right gate posts (B and C) the gate is to be installed. angling towards each other 4 degrees. Drill the holes for the gate. A. The gate is installed between two sections of fence. B.
- Page 8 In the event that custom panel sizes are needed, use After all the hole have been drilled and all panels the following process. have been installed, attach the safety hooks and eyes. ( It is recommended to locate custom panels at the back a.
-
Page 9: Warning
14. Complete the installation of the gate. ARNING Once fence panels have been installed and tension applied, hang gate by attaching hinges to frame HERE IS NO SUBSTITUTE FOR COMPETENT ADULT with the self-tapping screws supplied. SUPERVISION IN THE SWIMMING POOL ENVIRONMENT IVES DEPEND ON Note: Hinges should be attached...
Need help?
Do you have a question about the PROTECT-A-POOL 4300501 and is the answer not in the manual?
Questions and answers