Before Starting The Equipment; Operation - EINHELL CC-IW 950/1 Operating Instructions Manual

L sound pressure level ........................ 88 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level .......................... 99 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 62841.
Tightening screws and nuts of maximum per-
mitted size
Vibration emission value a
K uncertainty = 1.5 m/s
The stated vibration emission levels and stated
noise emission values were measured in ac-
cordance with a set of standardized criteria and
can be used to compare one power tool with
another.
The stated vibration emission levels and stated
noise emission values can also be used to make
an initial assessment of exposure.
Warning:
The vibration and noise emission levels may vary
from the level specifi ed during actual use, depen-
ding on the way in which the power tool is used,
especially the type of workpiece it is used for.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
Anl_CC_IW_950_1_SPK9.indb 16 Anl_CC_IW_950_1_SPK9.indb 16
= 10.32 m/s
2
h
2
- 16 -
GB
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
Bit insertion/removal (Fig. 2/Item 1)
Push a drive socket insert onto the square drive
mount (1).
To remove it, pull the drive socket insert off of the
square drive mount (1).

6. Operation

Danger!
To avoid danger, the machine must only be held
using the two handles (2). Otherwise you may
suff er an electric shock if you drill into electric
cables!
6.1 Clockwise/Counter-clockwise selector
switch (Fig. 3/Item 3)
You can select clockwise or counter-clockwise
rotation using the rocker switch (3).
R → loosen screws / nuts (counter-clockwise)
F → tighten screws / nuts (clockwise)
Important!
To avoid gear damage, make sure that the tool
has come to a complete stop before you change
the direction of rotation.
26.02.2024 09:15:16 26.02.2024 09:15:16