Advertisement
Remote Control Operation for EW300X:
Wireless Remote: Pairing and Programming
1. All remotes operate at 433.92MHz. Operating more than one wireless
remote in close range will cause interference with other units if paired
incorrectly.
2. Power off the spotlight by removing the fuse or disconnecting from
main power. Install the fuse or reconnect to main power, then press the
▲ and ▼ buttons simultaneously within 5 seconds.
3. When programming is successful, the spotlight will flash 1 to 4 times.
Each flash represents which memory slot the wireless remote is
programmed to.
4. One wireless remote can be programmed to 4 spotlights. The
spotlight will remember up to 4 wireless remotes.
5. To program more than one remote, follow existing steps to pair remote
within initial 5 seconds of power up.
6. Each unit can be controlled by a single remote if the single remote is
paired through all four channels as directed above. This means one
vehicle can control up to 4 spotlights with four different remotes.
7. The optional in-dash controller will override the wireless remote.
8. In open air with full powered 23A batteries, the wireless remote will
have a 65M range.
Remote Control Operation for EW301X:
LED INDICATOR:
WHEN ANY BUTTON IS PRESSED, THE LED
INDICATOR WILL BE ON TO SHOW IT IS
TRANSMITTING SIGNALS, GREEN LED
MEANS SUFFICIENT BATTERY POWER, RED
LED MEANS POWER LOW, SUGGEST TO
CHANGE BATTERY.
Wireless Joystick Programing Process:
1.
Operating more than one wireless remote in close range will
cause interference with other units if paired incorrectly.
2.
The wireless joystick control must remain connected to power
during the pairing process.
3.
Power off the spotlight by removing the fuse or disconnecting
from main power. Install the fuse or reconnect to main power,
then press the programming button on the rear side of the joystick
control within the initial 5 seconds of powering up.
4.
When programming is successful, the spotlight will flash.
5.
To program more than one remote, follow existing steps to pair
remote within initial 5 seconds of power up.
EW301X: SPEED FAST/SLOW
POWER
ON/OFF
BUTTON
NOTE: The light beam direction is adjustable while the spotlight is off.
Use
LIGHT BEAM
DIRECTION OPERATION
EW300X: STROBE ON/OFF
LED
ON/OFF
BUTTON
back
Programming Button
Page 3 of 6
Advertisement
