Panasonic SL-CT485 Operating Instructions Manual page 5

a a
J i+ear.t
a ea ees
EAA
Control
The remote control can be operated regard'ass of the
HOLD mode of the unit.
Preparation:
Release the remote control from the HOLD mode.
D Operation confirmation tones
When an operation button is pressed, a confirmation
tone sounds. Refer to the parentheses in the iltustra-
tion for the different types of confirmation tones.
To start play
To stop play
To turn off
the unit
(Beep...Beée...p)
Press during play.
(Press [Hid] twice to skip to the beginning of
Skipping | the previous tracks.)
tracks Backward
(Beep Beep Beep)
Forward
(Beep Beep)
Increase
To adjust the
volume
*The volume range is 0-25. (Press and hold
to change the volume successively.}
$A tone (beep-beep} sounds when you
reach the minimum of maximum volume.
Other operation
To change sound quality
See page 4.
Using the unit with an audio
system
Use stereo connection cable (not included) to listen to
COs through your home audio system,
Turn off this unit and the other equipment before con-
nection.
©Do not connect the cable to the PHONO jacks on the
amplifier.
© Obtain the optional connecting cable if the other equip-
ment comes with mini-phone jacks.
°Set this unit's volume to 10, then adjust the volume on
the other equipment.
eYou can connect speakers, active or otherwise, with
an impedance of 1 kQ or less to the headphone jacks,
Headphone jack (Q)]
ə To CD or AUX
> terminals
Stereo connection cable (not included)
Using the unit with a car audio
system
Items to be purchased
For connection to the car audio system:
Car stereo cassette adaptor (SH-CDM10A)
Connect the car stereo cassette adaptor to the
unit's headphone jack.
{When doing this, set this unit's volume to 10.)
For securing the unit and connecting the power
supply:
Car adaptor (SH-CDC9)
Car mounting kit (SH-CDF20)
Note when using the car mounting kit {SH-CDF20)
Remove the screw from
the bracket at the rear
+ of the car mounting
|
| base.
| @Replace the screw in
- the lower hole of the
bracket.
Bracket
Screwdriver ;
eWhen you switch off the car, volume and sound quality
may rétum to the original settings and the resume
function may work even if you change the disc.
olt may not be possible to use the unit with some types
of car steraos owing to restrictions imposed by the
construction of the car stereo cassette adaptor.
For further details, refer to the instructions of the part
concerned.
'Maintaining
the Lens
Open the lid and clean the lans as shown in the figure.
Use a cotton swab to gently wipe off any finger-prints.
Recommended product:
Lens cleaner kit (SZZP1038C)
Air blower for
camera lens
RQT5759