Before Use; Parts Identification - Panasonic ES883 Operating Instructions Manual

Before use
This Wet/Dry shaver can be used for
wet shaving with shaving lather or for
dry shaving. You can use this water-
tight shaver in the shower and clean
itin water. Treat yourself to wet lather
shaves for at least three weeks and
notice the difference. Your Panasonic
WET/DRY shaver requires a little
time to get used to because your skin
and beard need about a month to
adjust to any new shaving method.
Charge the shaver for at least 8 hours
before using it for the first time or
when it has not been in use for more
than six months.
Parts identification
(see fig. 1)
Protective cap
System outer foil release but-
tons
Foil frame
System outer foil
Inner blade
Foil frame release button
On/Off switch
Switch lock button
Battery capacity monitor,
Charge status lamp
Trimmer
Trimmer switch
Charging adaptor with auto-
matic voltage adjustment
Wall mount
Wood screws
®®
ses 00000000000
How to use the wall mount
The charging adaptor can be hung
on the wall using wood screws (in-
cluded).
1. Select an appropriate location on
the wall where the screws can go
in.
2. Attach the wall mount to the wall
as shown with the wood screws,
making sure that the arrow points
up.
3. Slide the charging adaptor
grooves into the wall mount until
it clicks in.
To remove the charging adaptor from
the wel mount, slide the adaptor up-
ward.
Charging
(see fig. 2)
Place the charging adaptor upright
on a flat surface or mount it on a wall.
Plug the adaptor into an AC outlet.
It will adjust automatically to voltages
between 100-120 and 220-240V AC.
Do not recharge the shaver from the
SHAVERS ONLY outlet (AC220-
240V) which is usually in hotel bath-
rooms in European and Asian coun-
tries as it will damage the charging
adaptor and/or outlet.
In some areas, a special plug adap-
tor may be required.
Switch the shaver to the "O * charge"
position and place it upright into the
charging adaptor with the switch fac-
ing toward the front.
The charge status lamp will glow red
when the shaver is placed on a right
charging position. It will turn to green
when the charging is completed (see
fig. 2A).
At the same time, the battery capac-
ity monitor will display the fully
charged condition (see fig. 2A). You
can fully charge the shaver in one