Advertisement
1.
2.
1.
2.
6
7
Screw in the spring screw pillar to complete the air
cooler and motherboard installation
對準背板螺絲孔位，使用彈簧螺絲完成散熱器安裝
3
11
www.xigmatek.com
E-mail: sales@xigmatek.com
is Registered Trademark of Xigmatek Co., LTD.
Copyright
2023-2027 All Rights Reserved
9
3
11
Clip the cooling fan to the heat sink, repeat agian for the second fan to complete dual fan installation
(the second fan is not included).
使用鐵絲扣具安裝風扇，重複相同步驟安裝另一側風扇(第二顆風扇另購)
ARGB Connector Instruction (AIR-KILLER PRO Only)
ARGB 連接使用說明(僅限AIR-KILLER PRO)
● ARGB Mother SYNC Mode
● Mini ARGB LED Controller Mode
Please connect the 3pin ARGB connector to
Mini ARGB LED Controller, plug and play.
● 迷你 ARGB 控制器模式
將 3pin ARGB 連接頭插入迷你控制器並運作
Mini ARGB LED Controller Instruction(AIR-KILLER PRO Only)
10
SATA(To PSU)
連接電源供應器SATA
迷你ARGB控制器使用說明ARGB (僅限AIR-KILLER PRO)
M
Multiple Lighting Effect Mode
多樣化燈效模式
Click M Button to Switch Different LED Lighting Effects
(9 Lighting Effects)
單擊M按鈕切換不同燈效模式 (9種燈效模式)
M
S
LED Speed Adjustment
LED 燈效速度調整
Click M button to Enter Multiple Lighting Effect Mode
Click S Button to Change LED Speed
(5 LED Speeds Available)
單擊M按紐進入多樣化燈效模式
單擊S按鈕切換LED燈效速度 (5種LED燈效速度選擇)
OFF
ON
ON
C
M
2 SEC
LED On/Off
LED 燈光開關
Click S Button and Hold More than 2 Seconds for LED Off
Click M or C Button for LED On
長按S按鈕2秒鐘關燈
單擊M或C按鈕開燈
C
LED Single Color Mode
LED 單色模式
Click C Button to Switch Different LED Single Color
(7 Colors Available)
單擊C按鈕切換單一顏色LED燈效 (7種顏色選擇)
C
S
LED Brightness Adjustment
LED亮度調整
Click C Button to Enter LED Single Color Mode
Click S Button to Adjust LED Brightness
(4 Brightness Modes)
單擊C按鈕進入LED亮度調整模式
(僅提供單一LED燈效模式使用)
單擊S按鈕調整LED亮度 (4種亮度模式)
Advertisement
