Advertisement
Available languages
Available languages
Precautions
RR
a
1. Warranty
Card
The serial number is written on the rear panel of this unit. Copy
the serial number and model number onto your warranty card
and keep it in a safe place.
2. Care
From time to time you should wipe off the front and rear panels
and the cabinet with soft cloth. For heavier dirt, dampen a soft
cloth in a weak solution of mild detergent and water, wring it
out dry, and wipe off the dirt. Following this, dry immediately
with a clean cloth. Do not use rough material, thinners, alcohol
or other chemical solvents or cloths since these could damage
the finish or remove the panel lettering.
3. Power
WARNING
BEFORE TURNING
ON POWER
FOR THE FIRST TIME, READ
THE FOLLOWING
SECTION
CAREFULLY.
@
Some models are designed for use only with the power supply
voltage of the region where they are sold.
European models:
AC220V, 50Hz
Canadian models:
AC120V, 60Hz
British & Australian models:
| AC 240V, 50Hz
Worldwide models:
120 and 220V switchable,
50/60Hz
Supplied accessories
fR | remote control cable x 1
Output signal cord x 1
System connections
Voltage Selector (Rear Panel)
Worldwide models are equipped with a voltage selector to conform
with local power supplies. Be sure to set this switch to match the
voltage of the power supply in your area before turning the power
switch on. Voltage is changed by sliding the groove in the switch
with a screwdriver to the right or left. Confirm that the switch has
been moved all the way to the right or left before turning the power
switch on. Models without a voltage selector can only be used in
areas where the power supply is the same as that of the unit.
220V™
at AC220V
220V
120V™
at AC120V
120V%
Tuning Step Frequency Switch
(Rear Panel)
Worldwide models are equipped with a switch that controls the
AM (9kHz/10kHz)
and FM (50kHz/200kHz)
bands tuning steps.
Be sure to set this switch to match the tunig step frequency in your
area.
U.S.A:
Other area:
10 kHz/200 kHz
9 kHz/50 kHz
AM loop
antenna x 1
T-shaped FM
antenna x 1
©
Do not plug in the power cord until all connections have been completed.
Models for some areas
are equipped with a
screw-type
FM antenna
terminal (75/300 ohms).
Outdoor
FM antenna
Indoor T-shaped
antenna
Do not connect both indoor and
outdoor FM antennas.
{f you decide to
instatl an outdoor antenna, be sure to
disconnect the indoor feeder antenna.
AM
loop antenna
Outdoor AM
antenna
Worldwide models only
FAI
REMOTE
OUTPUT
CONTROL
Worldwide
models only
To the (QE remote control jack
Do not connect any product
to this jack that does not
have the Onkyo
{QI
mark.
To Amplifier
When
connecting tuner output to the amplifier,
be absolutely sure to connect the R (right) and L
(left) channets correctly
FM
Antenna
Connections
ONKYO
CORPORATION
'MADE IN JAPAN
VOLFAGE SELECTOR
Fad
CAUTION
bv FX oun!
RISK OF ELECTRIC SHOCK
X
gf
/ \
ee
A\
ee
re)
WARNING: SHOCK HAZAAD.po not oFen,
AVES: BISQUE DE CHOC ELECTRIQUE.ne Pas ovvate
ONKYO.
QUARTZ SYNTHESIZED
FM STEREO/AM TUNER
MODEL NO. T-4300
RATING:
ACIZV
6OH72
_10Ww
AC Power Supply
position in which reception is best. {f signal strength is low in your
area, use a multi-element FM outdoor antenna.
Consult your Onkyo
authorized service center about the right type of antenna for your
area.
-2-
Advertisement
