Table of Contents
Advertisement
WARNINGS
POWER
• Only use the power unit provided to power the device. Check mains rating before
plugging the power unit in.
• Do not pull the cable to unplug the device.
SAFETY PRECAUTIONS
• Keep the device away from rain and humidity to prevent risk of fire and electrocution. Do
not introduce material (solid or liquid) inside. If this should accidentally occur, disconnect
the device from the mains and have it inspected by qualified personnel.
• Never open the device. In all cases, contact the qualified personnel or authorized service
• center for repairs.
• Keep the device away from children, to prevent accidental damage.
• Do not touch the device with wet hands to prevent electrical shock or mechanical dam-
age.
• Do not use the device if it should fall or the external casing is damaged. Risk of electro-
cution
• if the device is used in such conditions. Contact the reseller or your installer.
• It is advisable to disconnect the power wire if the monitor is not used for an extended
period.
INSTALLATION PRECAUTIONS
•
To prevent overheating the device, arrange it in a position allowing the flow of air through
the slots in the casing. Ensure at least 5 cm of free space when installing inside a rack.
•
For the same reason, do not install near sources of heat, such as radiators or hot air
ducts. Keep away from direct sunlight. Do not install in areas subject to excessive dust,
mechanical vibrations or shocks.
•
Do not arrange this device on an unstable surface, such as a tottering or slanted table.
The device could fall causing injury or mechanical failures.
•
Do not install the device in a place where it could be exposed to humidity or water. Do
not direct a jet of water onto the device: risk of fire, electrocution or mechanical failure.
•
Stop using the device if water or other material should penetrate inside: risk of fire and
electrocution. Contact the retailer or authorized installer.
•
Slots and openings in the cabinet are provided for ventilation. These openings must not be
blocked or covered.
•
Do not place heavy or heat generating objects on top of the device: this could damage
the casing and/or increase internal temperature causing faults.
•
Do not cover the device with a cloth while it is running to prevent deforming the external
casing and overheating the internal parts: risk of fire, electrocution and mechanical failure.
•
Keep magnets and magnetized objects away from the device to prevent faults.
•
Do not use the device in the presence of smoke, vapor, humidity, dust or intense vibra-
tions.
•
Wait for a while before operating a device immediately after transporting it from a cold
place to a warm place and vice versa. Wait on average for three hours: this will allow the
device to adapt to the new ambient temperature and/or humidity, etc.
•
The monitor is provided with a plastic base and rubber feet. It can be positioned on a
horizontal surface, such as a desk or a table. Make sure that the device is fastened firmly
and that it is not resting on unstable supports or surfaces. Dropping could cause severe
injury and damage the device.
•
Remember to adjust the brightness and contrast to obtain a perfect image.
•
The monitor can also be installed on the wall by means of a bracket (not provided).
4
Advertisement
Table of Contents
