Ii, Head Azimuth Adjustment - Akai PM-R1 Service Manual

Il. HEAD AZIMUTH ADJUSTMENT
ADJ HOLE
(aq) HEAD AZIMUTH ADJ. SCREW
1) Playback the azimuth adjustment tape (10 kHz
AT-750778) in the FWD PLAY mode and adjust
screw (a), until the output level of both channels
reaches maximum (the AC voltmeter registers max-
imum). | 7
2) Put in reverse mode and check that the output level
is the same as in the forward mode. If different,
adjust with screw (a), until the level is the same in
both modes.
3) After adjustment, paint lock the screw (a).
SERVICE MANUAL PM-R1/FAM-1
Fig. 3-1