Red Sky Global Block-Mini Series Operating Instructions

Operating Instructions
Warranty
Red Sky Lighting LLC. Rancho Cucamonga CA, USA
Page: 8
www.redskylighting.com 1 (262) 456-5002
Series Operating Instructions
General Safety Information
To reduce the risk of death, personal injury or property damage from fire,
electric shock, falling parts, cuts/abrasions, and other hazards, read all
warnings and instructions included with and on the luminaire box and all
luminaire labels.
Before installing, servicing, or performing routine maintenance upon
this equipment, follow these general precautions.
Commercial installation, service and maintenance of luminaires
should be performed by a qualified licensed electrician.
DO NOT INSTALL DAMAGED PRODUCT!
This luminaire is intended to be connected to a properly installed and
grounded UL listed junction box.
Make sure that the supply voltage is the same as the luminaire voltage.
Do not install where the marked operating temperatures exceed the
ignition temperatures of the hazardous atmosphere.
Do not operate in ambient temperatures above those indicated on the
luminaire nameplate.
All gasket seals must be clean and undamaged.
WARNING:
RISK OF ELECTRICAL SHOCK
Turn off electrical power at fuse or circuit breaker box before wiring luminaire to the power supply.
Turn off the power when you perform any maintenance.
Verify that supply voltage is correct by comparing it with the luminaire label information.
Make sure all electrical and grounded connections in accordance with the National Electrical
Code and any applicable local code requirements and Hazloc requirements and suitable for wiring systerm..
All wiring connections should be capped with UL approved wire connectors.
Luminaire must be supplied by a wiring system with an equipment grounding conductor.
CAUTION:
RISK OF INJURY
Wear gloves and safety glasses at all times when removing luminaire from carton,
installing, servicing or performing maintenance.
Avoid direct eye exposure to the light source while it is on.
Account for small parts and destroyed packing material,
as these may be hazardous to children.
CAUTION:
Keep combustible and other materials that can
burn away from luminaire and lamp/lens.
MIN 90°C SUPPLY CONDUCTORS.
Red Sky Lighting LLC. Rancho Cucamonga CA, USA
Picture is for illustration purposes only.
Your model may vary
Model Series is suitable for use in
the following hazardous (classified) areas as
defined by the National Electrical Code (NEC)
and Canadian Electrical Code (CEC):
For Class I, Division 1 Luminaires, suitable for locations having
deposits of readily combustible paint residues
Hazardous Locations
Class I, Division 2, Groups A, B, C, D
Class II, Division 1, Groups E, F, G
Class II, Division 2, Groups F, G
Class III , Division 1
Refer to the luminaire nameplate for specific classification
information, maximum ambient temperature suitability and
corresponding operating temperature (T-Code).
Page: 1
www.redskylighting.com 1 (262) 456-5002
Series