Advertisement
Quick Links
www.c-racer.com
CONTENTS
1. 1pcs
Rear Fender
2. 2pcs screws Μ5Χ15 (
3. 2pcs washers 5Χ15
4. 1pcs Foam tape sticker 30X5X150
(placed by us)
Remove the protective mudguard on the rear wheel as shown in the photo.
You will not use the screws and the mudguard again, so you can save them if you want to restore it at the original
form
Then remove the screws that secure the chain guard to the inside only. You will not use these screws
again (left photo).
Finally remove the base that holds the rear brake hoses. The base and the screws will be used again.
(right photo).
Model
ΥΑΜΑΗΑ Tenere 700/T7
allen-oval-washer
)
INSTRUCTION
Page 1/2
Product
Rear Hugger
1.
Code
RH-YT7
2.
Advertisement
Related Manuals for C-RACER RH-YT7
Summary of Contents for C-RACER RH-YT7
- Page 1 INSTRUCTION Page 1/2 Product Code Model Rear Hugger ΥΑΜΑΗΑ Tenere 700/T7 RH-YT7 www.c-racer.com CONTENTS 1. 1pcs Rear Fender 2. 2pcs screws Μ5Χ15 ( allen-oval-washer 3. 2pcs washers 5Χ15 4. 1pcs Foam tape sticker 30X5X150 (placed by us) Remove the protective mudguard on the rear wheel as shown in the photo.
- Page 2 Make sure the part is in place and tighten all the screws. Finally remove the protective film. This will be the end result. Enjoy your clean rides! The product is for race use only For any further information please do not hesitate to contact us: Tel.: +30 2108075387 Email: info@c-racer.com...