Advertisement
Available languages
Available languages
English
An electro-mechanical height-adjustable work surface with a control interface to adjust the
height up and down. This product can be used by children aged from 14 years and above
and persons with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of the product
in a safe way and understand the hazards involved by a person responsible for their safety.
Children shall not play with the product. Cleaning and user maintenance shall not be carried
out by children without supervision.
Translated from the original instructions.
Advice and instructions for MITTZON sit/stand desk.
Model:
Input:
Sound level:
Standby power consumption:
Height setting interval:
Maximum load:
Temperature interval at usage:
Temperature interval at storage:
Humidity:
Power supply unit:
This product shall only be used together with the
included power supply unit.
Every person who is responsible for this table at installation
or employment of the table in daily use or in service and
repair work should carefully read these instructions. Keep
these instructions close to your sit/stand table.
Installation instructions
The table is assembled according to separate assembly
instructions. Connect one side of the 90-degree connection
cable (50mm long) to the M1 port on the control box, then
connect the other side to the cable from the leg. Connect
the cable from the other leg to the M2 port on the control
box. Connect the hand controller to the HS port and the
power supply to the AC port on the control box. The control
box should be placed in the tray created by the frame,
and the electrical cable should be placed in the felt tray
on the back. Position the electrical cable so it does not get
damaged. Please check the assembly instructions. Connect
the electrical cable to a wall socket (or a socket placed in the
felt tray).
Note! The electrical cable must have full mobility.
The table is now ready for use. The motors will stop
automatically when the table reaches its lowest or highest
position respectively.
MITTZON
AC 110V or 230V, 50/60Hz
Lower than 50 dB(A)
<0.2W
62~126 cm, 24.4~49.6 in
80 kg/176 lbs
+5 up to +40 °C/41 up to 104°F
-10 up to +50 °C/14 up to 122°F
20% up to 80% at +30 °C/86°F
DC max 30V, 350W
Usage of the table
The table shall only be used as a working table with the
possibility to continuously adjust the working height
between sitting and standing positions. The table shall only
be used indoors and in dry premises (office environment or
similar).
The table must not be overloaded - maximum load is 80
kg/176 lbs. The motors may be run continuously for a
maximum of 2 minutes. Afterwards, the motors must
rest for approx. 18 minutes. before they can be used
again.
Follow these instructions when adjusting table height:
1. Make sure all cables are connected firmly in place.
2. Make sure no objects are in the way of the table so that
the height can adjust freely.
3. Press the up/down buttons on the hand controller to
adjust the desk height.
4
Advertisement
