Table of Contents
Advertisement
en Water system
Dispensing ice or water
To activate setting mode, touch the
1.
lower area of the control panel.
Press the required selection op-
2.
tion
and press the glass against
the dispensing button .
Tip: Hold the glass directly under
the dispenser opening.
Notes
¡ After a while of continuous dis-
pensing, the ice or water stops
being dispensed. Wait a few
seconds before dispensing ice
or water again.
¡ After ice or water has been dis-
pensed several times consecut-
ively, it stops being dispensed.
Wait a few minutes before dis-
pensing ice or water again.
¡ When changing from
to
crushed, a few ice cubes
may be released the next time
you dispense.
¡ When changing from
to
cubes, a small amount of
crushed ice may be released
the next time you dispense.
Bottle fill option
You can dispense a specific amount
of water with the bottle fill option.
Note: The factory-set amount of water
is approx. 900 ml.
30
Filling a bottle
1.
2.
3.
a The set amount of water is dis-
Tips
¡ To stop dispensing early, press
¡ To start dispensing again, press
Note: If you do not fill a bottle for
some time, the selection option
changes to water.
Setting the amount of water for the
bottle fill option
Note: The maximum fill time is
cubes
60 seconds.
1.
2.
crushed
3.
Press bottle.
Place a bottle or jug under the dis-
penser opening.
Press bottle.
pensed.
any touch field on the control
panel.
bottle.
Press bottle.
Place a bottle or jug under the dis-
penser opening.
Select one of the options:
Press and hold bottle at the
‒
same time until the desired
amount of water is dispensed.
Press
/
‒
ment) repeatedly until the tem-
perature display (freezer com-
(Freezer compart-
Advertisement
Table of Contents
