Philips Fidelio DCW8010 Quick Start Manual

DCW8010
wireless music system with
AirPlay
Quick start guide
Always there to help you
Register your product for further support at
www.philips.com/welcome
AirPlay
Check your iOS version
Before using your product, read all accompanying safety information.
Lesen Sie vor der ersten Verwendung Ihres Produktes alle beiliegenden Sicherheitsinformationen.
Antes de usar el producto, lee toda la información adjunta a la de seguridad
Veuillez lire toutes les consignes de sécurité fournies avec votre produit avant de l'utiliser.
Upgrade your iPod touch, iPhone, or iPad
to iOS 4.3 or above.
Note: Make sure that Wi-Fi is enabled on
your iPod touch, iPhone, or iPad.
If your router has a WPS button, you can connect the
device to the router through WPS.
Press WIFI SETUP, then the light blinks green and
yellow alternately.
Press the WPS button on your home Wi-Fi router.
e subject to change without notice
Wait up to 2 minutes until the light stops blinking and
©2012 Koninklijke Philips Electronics N.V.
All rights reserved. you hear a confirmation tone.
DCW8010_10_QSG_V1.1
Quick start guide
Option 1: Use iOS 5 Wi-Fi network login sharing (recommended)
Your Wi-Fi Network
5.X
Connect your iPod
touch/iPhone/iPad to your
home router by Wi-Fi.
Option 2: Set up through webpage configuration
X.X.X
Settings General About
4.3
192.168.1.1
Open Safari. Enter the IP address 192.168.1.1.
USB
PROG/
CLOCK
PROG/
CLOCK
Wait 35sec
WiFi SETUP
Wait for 35 seconds until the light in the middle Dock your iPod touch/iPhone/iPad
of the WIFI SETUP button turns to solid yellow. onto the system.
Wait 35sec
WiFi SETUP
Open Settings.
Wait for 35 seconds until the light in the middle Tap Wi-Fi.
of the WIFI SETUP button turns to solid yellow.
Wait< 2min
If it takes more than 2
minutes to see the screen of
step 8, try to turn on/off the
Airplane mode (Settings ->
Airplane Mode) and start
from step 2 again.
If the problem remains,
restart your iPhone and start
from step 2 again.
Wait up to 2 minutes until the
Follow the on-screen instructions to
light stops flashing and you hear
configure the Wi-Fi settings for this system.
a confirmation tone.
CD
PROG/
3 sec
CLOCK
MP3-LINK
Wait< 1min
WiFi SETUP
Tap ALLOW (allow) to share your Wait up to 1 minute until the light
Wi-Fi settings with this system. stops flashing and you hear a
confirmation tone.
Philips DCW8010 XXXXXX
Remember to turn on
Wait<30sec
the 3G network after
Settings General Network successful AirPlay
connection.
Wait up to 30 seconds until "Philips DCW8010
Disable the 3G network.
XXXXXX" is detected. Then, tap it.
If the light does not turn solid green after 2
minutes, reconnect the power adaptor, and then
repeat steps from beginning.
To change Wi-Fi setup after first-time setup,
press and hold WIFI SETUP for more than 3
seconds to reset Wi-Fi settings. Then follow the
previous steps to change your network settings.
Your Wi-Fi Network
Open Settings. Check your router is selected. Open iPod application.
Philips DCW8010 XXXXXX
Tap AirPlay icon . Select this system. Tap to play music.
If the AirPlay icon does not appear or there is no sound output, try the following ways:
Turn on and off the Airplane Mode in Settings.
Restart your iPhone.
It is recommended to restart your home router.