B&D FHCRX-1V2 Installation Instructions

Multi-Frequency Receivers
FHCRX-1V2, FHCRX-2V2 and FHRX-2V2 Installation Instructions
Thank you for purchasing an ATA Receiver. Familiarise yourself with the following instructions prior to commencing set up. Store this
information in a safe place for future reference. There are 2 types of Multi-Frequency Receivers;
a. The FHCRX-1 or FHCRX-2 series receivers have relays on board which provide normally open or normally closed contact for controlling
virtually any electronic device including garage doors and gate openers. The relays can be programmed to any three modes - pulse,
hold or timer. One or both relays can be programmed with any of the three modes.
NOTE: Timer mode is select able only with the ATA Programmer. Refer to the Programmer's manual for instructions on setting Timer
mode.
b. The FHRX-2 receiver has transistors on board which provide an open collector contact for controlling virtually any electronic garage
door or gate.
SETTING RELAY OPERATING MODES (FHCRX-1V2 and FHCRX-2V2)
Pulse Mode - Relay contact is active whilst transmitter button is pressed.
Hold Mode - Relay changes state at each press of transmitter button. Hold, Release, Hold,
etc. (like an on/off switch).
Timer Mode - Relay will remain active for the programmed duration.the timer is adjustable
from 0 seconds to 655.34 seconds in .01second steps
RELAY-1 Pulse Mode - Remove JP1 jumper or do not bridge the two pins.
RELAY-1 Hold Mode - Bridge the two pins on JP1 jumper.
RELAY-2 Pulse Mode - Remove JP2 jumper or do not bridge the two pins.
RELAY-2 Hold Mode - Bridge the two pins on JP2 jumper.
PG3-CONNECTOR PG3-CONNECTOR
CONNECTING FHCRX TO ATS-2, ATS-3,
SDO-6, SDO-7, SDO-8, SDO-9
Doc # 160025_00
Doc # 160025_01
Part # 13365
Part # 13365
Released 16/09/13
Released 15/03/23
SW1
JP1
FHCRX-1V2 shown
LED
AUX
CONNECTING FHCRX TO GDO-6, GDO-9
PG3-CONNECTOR
SW1
OSC 0V SB2 0V SB1 V+
LED
JP1