Table of Contents
Advertisement
Fault
E:61-03 will light up
alternately. Water is
not drained.
E:92-40 will light up
alternately.
All LEDs lit up or
flashing.
Cause and troubleshooting
Not an appliance fault. Siphon connection is still
closed or the wastewater hose is kinked or blocked.
Check the connection to the siphon and open if ne-
1.
cessary.
Install wastewater hose without kinks.
2.
Remove residues.
3.
Not an appliance fault. Wastewater pump is blocked
or the cover of the wastewater pump is loose.
Clean the wastewater pump.
1.
→ "Clean wastewater pump", Page 47
Secure the cover of the wastewater pump so it
2.
clicks into position.
→ "Clean wastewater pump", Page 47
Filters are soiled or blocked.
Clean the filters.
▶
→ "Cleaning filters", Page 39
A software update is possibly installing.
Wait until the software update has been installed.
1.
This process can take approx. 30 minutes.
If the appliance is not ready to use after
2.
30 minutes, perform a reset.
Press the main switch button for approx.
‒
4 seconds.
a Your appliance is resetting.
Troubleshooting en
43
Advertisement
Table of Contents
