Getting Started; Inserting The Sim Card; Charging The Battery - Philips CT1208-SBUA10A7 Manual

Getting started

L

Inserting the SIM card

1 Remove the SIM card from its holder and insert in its slot,
under the metal clip holder, push until it stops. Be careful that
the clipped corner of the card is in the correct position as
shown opposite.
2 Slide the battery pack into its slot until it stops (1) and push
the clip downwards (2).
3 Place the phone's battery cover, by sliding it until the latch
catches.
4 Remove the protective film from the screen before using the
phone.

Charging the battery

L
1
Read the safety instructions in the "Precautions" section before use.
Your phone is powered by a rechargeable battery.
• For a full recharging please allow the charger to be connected for about 10
to 14 hours (e.g., over night).
• To optimise battery capacity, allow it to fully discharge 3 times in a row.
Then, to maintain its optimal capacity, do not wait until the indicator
reaches low (i.e., when only 1 bar is displayed in the battery indicator).
• Disconnect the battery if you do not use the phone for several days.
• You can use the phone while it is on charge.
• If the battery is completely flat, the battery icon will only reappear after 2
or 3 mn of recharging. Meanwhile, you cannot make a call.
Once the battery and the battery cover are connected to the phone, plug
the connector into the right hand socket at the base of the phone.
3