PEERLESS Lightedge EGCM1L Installation Instructions

PIN004102
LED IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS! SAVE THESE INSTRUCTIONS AND DELIVER TO OWNER AFTER INSTALLATION
• To reduce the risk of death, personal injury or property damage from fire, electric shock falling parts, cuts/abrasions, and other hazards, please read all warnings and instructions included with and on the luminaire box
and all luminaire labels.
• Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
• Installation and service of luminaires should be performed by a qualified licensed electrician.
• Maintenance of the luminaires should be performed by person(s) familiar with the luminaires' construction and operation and any hazards involved. Regular fixture maintenance programs are recommended.
• It will occasionally be necessary to clean the outside of the refractor/lens. Frequency of cleaning will depend on ambient dirt level and minimum light output which is acceptable to user. Refractor/lens should be washed
in a solution of warm water and any mild, non-abrasive household detergent, rinsed with clean water and wiped dry. Should optical assembly become dirty on the inside, wipe refractor/lens and clean in above manner,
replacing damaged gaskets as necessary.
• DO NOT INSTALL DAMAGED PRODUCT! This luminaire has been properly packed so that no parts should have been damaged during transit. Inspect to confirm. Any part damaged or broken during or after assembly
should be replaced.
• Recycle: For information on how to recycle LED electronic products, please visit www.epa.gov.
• These instructions do not purport to cover all details or variations in equipment nor to provide every possible contingency to meet in connection with installation, operation, or maintenance. Should further information
be desired, or should particular problems arise which are not cover sufficiently for the purchaser's or owner's purposes, this matter should be referred at Acuity Brands Lighting Inc. a parent company of Peerless Lighting.
WARNING
RISK OF ELECTRIC SHOCK
 Disconnect or turn off power before installation or servicing.
 Verify that supply voltage is correct by comparing it with the
luminaire label information.
 Make all electrical and grounded connections in accordance
with the National Electrical Code (NEC) and any applicable
local code requirements.
 All wiring connections should be capped with UL approved
recognized wire connectors.
 To prevent luminaire row from over-current: by adding the
input current of each luminaire section marked on the
luminaire, the total per power feed must not exceed the
maximum line wire amperage marked on the luminaire and
the power feed cord/wire amperage rating whichever the
least.
© 2024 Acuity Brands Lighting Inc. All Rights Reserved. Products in this document may be cover by one or more U.S. Patents and Patents Pending. Specifications subject to change without notice. Limited warranty applies.
Complete warranty terms located at
K
 Allow lamp/fixture to cool before handling. Do not touch
enclosure or light source.
 Do not exceed maximum wattage marked on luminaire
label.
 Follow all manufacturer's warnings, recommendations and
restrictions for: driver type, burning position, mounting
locations/methods, replacement and recycling.
www.acuitybrands.com/support/warranty/terms-and-conditions
Rev. D 2/2024
K
WARNING
RISK OF BURN
 Wear gloves and safety glasses at all times when removing
 Avoid direct eye exposure to the light source while it is on.
 Keep combustible and other materials that can burn, away
 Do not operate in close proximity to persons, combustible
K
WARNING
RISK OF INJURY
luminaire form carton, installing, servicing or performing
maintenance.
K
WARNING
RISK OF FIRE
from lamp/lens.
materials or substances affected by heat or drying.