Phenom 18885 User Manual

Please read the following user guide carefully and keep it to avoid ac-
cidents.
Usage
This portable LED worklight can be used either as a mobile, torch light or
as a fixed, desk light.
You can only use this light within dry conditions. Failure to follow all in-
structions listed below, may result in electric shock, fire and/or serious
personal injury.
Safety Notes
Important: If you use the LED worklight without first reading and under-
standing the information in this user guide, injury can result from expo-
sure to high-intensity light. To reduce the risk of injury, read and ensure
you understand the informations in this user guide before assembling and
operating the worklight.
Prior to use this LED worklight, read and understand all the related instruc-
tion listed below in order to avoid any serious injury or damage. Warran-
ty cannot apply if this product is damaged by abuse, misuse or lack of
maintenance, we are not responsible for any personal injury caused by
neglience.
Danger:
- Keep the user guide in a safe place and give it to a third party in any
other cases.
- Do NOT use it in wet humid place because of danger of fire and electric
shock. Ingress protection: IP 40.
- Do not change or modificate this product. Any modification can cause
injury or electric shock and prohibited according to the conformity (CE)
markings.
- Always check the main supply voltage. Ensure that the specifications can
match and be applied with the device. Failure to observe the safety rules
and standards can cause fire, electrical shock or damages.
- Do not use the product if it is broken or damaged. If you experience any
damage or crack on the product, do not use it. Damages can be caused by
any percussion, impact or drop. Inspect before each use and if you have
any problem, contact a technician. Failure to follow these instructions may
result electric shock or any personal injury.
- Keep out of the reach of children. Do not leave the installed worklight with-
out supervision. Children must not use the worklight.
- Do not allow to any unauthorized person to use the product. If the product
is not in use, store it in a cool, dry place where children cannot reach that.
Product code / Termékkód / Cod produs / Kód produkta:
18885
- Always keep worklight away from any flammable surfaces or materials.
- This product is not waterproof. Do not submerse in water.
- The battery may explode. Do not expose to fire or high temperetures.
Warning:
- Do not illuminate directly into eyes. Direct illumination can cause serious
ocular problems.
- Ensure that the cable placed in a safe area and cannot cause any dan-
gerous obstacles.
Warning:
- Prevent the conjunctive cable from oil, sharp edges and high tempera-
ture. Disregarding this information can result injuries.
- Ensure the environment where you want to place the item. Do not place
it to high-temperature or on direct sunlight.
- Do not cover your worklight fully, leave minimum 10 cm safety distance
where the heat can leave properly.
- In case of thunderstorm, rain or thunderstroke, immediately disconnect
the device from the power supply in order to prevent any damage.
- Only use original parts and accessories of the product.
Specifications:
Ingress Protection:
Battery:
Charger Unit:
Lamp's Flux:
Installation and Usage:
Before operating or maintaining this product, please read this manual
carefully paying extra attention to the safety warnings and precautions.
- Charging Instructions:
Pull the light unit out from the cover then connect the charger unit by
a micro USB socket. Through the battery unit you can charge other USB
connected devices, in these cases use the USB A socket. The mains adapter
indicator light will flash in RED during the charging process. The indicator
light will change to continuous RED light once the battery has been fully
charged. The charging time is approximately 4 hours. Fully charge the unit
in each and every 2 months even if the product is not in use.
- Torch function
The light operates for approximately 7 hours in the maximum brightness
set (2nd option) and for approximately 10 hours in low brightness option
IP40
3.6 V 2600 mAh
USB 5 V
350 lumen