Table of Contents
Advertisement
TROUBLE SHOOTING
Power is turned on, but indicators do]
1.
Power plug is not connected securely.
not light.
Drawer Open/Close button is
pressed,
but Drawer does not open.
Disc is loaded, but total number of
programs
is not displayed.
Cause
Insert the power plug into the power outlet
securely.
1.
Open signal is not received correctly.
Disc is dirty.
Play/ Pause button(®/ 88) is
pressed, but play does not begin.
No sound is produced.
Disc is loaded upside down.
Disc used is nonstandard.
1. Press the Drawer Open/Close button again
and confirm the Open/Close indicator is
flashing.
Load the disc correctly.
Clean the surface of the disc.
Replace the disc.
Disc is dirty.
AV
di
|]
GO
NA
i Sound
iS dicionied:
|
A particular spot on the disc does
nat play correctly (sound cuts out, or{2.
Disc is dirty.
same spot is repeated).
Disc has scratches or is warped.
Connector pin-cords are not connected.
being clipped.
PRECAUTIONS FOR USE
Discs
which
can
be played
on
this
player
have
the following
mark
on
them
During playback, if the player is subjected to a sud-
den shock
or jolt, some
noise may be produced.
This is not a malfunction.
If the player is operated while you are receiving an
FM/AM radio broadcast, you may hear noise on the
radio broadcast.
In this case, turn the CD player's
power switch off.
If other audio components or their connecting cords
are installed near this player, you may hear a hum-
ming sound.
In this event, try changing the location
of the other components or their wiring.
Whenever moving the player, be sure to first remove
the disc from it. if the player is moved with a disc
loaded, the disc may be damaged.
The gcd-200/gcd-300 has a wide dynamic range.
As
a result, if you turn your amplifiers volume up too
high during soft (low volume)
parts of a program,
your speakers may be damaged when the dynamic
range of a sudden loud passage is produced.
dis
DIGITAL
AUDIO
Clean surface of disc.
Replace disc.
Connect the connector pin-cord to the output
terminals of the player and the input
terminals of the amplifier.
ma
IN)
= INN
1. Connections to amplifier are wrong.
2. Amplifier output is set too high and sound is
1. Disc has scratch or other damage.
Connect player to amplifier correctly.
. Turn down the amplifier output volume.
1.
Use the Fast forward/Index
button to pass
over the part scratched.
Clean the surface of the disc.
Do not move
the player suddenly from a very cold
room
into a warm
room.
When a chilled player is
moved suddenly to a warm
location, moisture con-
densation may form on the pickup lens, preventing
proper
operation.
In this case,
wait 30 minutes
before resuming play.
Do not place foreign objects in the disc drawer and
attempt to operate the drawer control (Open/Close)
function.
It may cause damage to the mechanism.
Do
not
store
discs
in high-temperature,
high-
humidity locations.
The discs may develop warps
and become
unplayable.
Also, discs with moisture
on them may be unplayable.
Wipe any moisture off
with a soft, dry cloth, and be sure discs are fully dry
before using.
If the unit is installed in a confined
location,
heat
dissipation
will
be
poor
and
malfunctions
may
occur.
Also,
do
not
install
the
unit
on
top
of
amplifiers or other components liable to become hot.
17
Advertisement
Table of Contents
Need help?
Do you have a question about the gcd-200 and is the answer not in the manual?
Questions and answers