Advertisement
Advertisement
Summary of Contents for AMP COMMAND FLOW 3000
- Page 2 Congratulations on your purchase of pressure washer. You can be confident that this pressure washer is constructed and tested with optimum performance and quality in mind. Reading this manual will help get you the best results for set-up, operation, maintenance and avoid personal injury or damage to your machine.
-
Page 3: Table Of Contents
TABLE OF CONTENTS ..................3 ....................4 Safety Information ....................5 Assembly Instructions................... 7 Operating Instructions ..................Care and Maintenance ..................1 Pump Saver ......................1 Troubleshooting ....................1 Limited Warranty ....................1 PRODUCT SPECIFICATIONS SPECIFICATIONS Model Max PSI Max GPM Cold Water Volts... -
Page 5: Safety Information
SAFETY INFORMATION SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble and operate the product. carefully and only when you are alert. 10. Watch your balance and footing while using your power This manual contains information that relates to washer. - Page 6 SAFETY INFORMATION SAFETY INFORMATION detergent. disconnect the high pressure hose from the 26. Warning-If connection is made to a potable water power washer while the system is pressurized. system, the system Should be protected against permanently engage the trigger mechanism on the spray gun.
-
Page 7: Assembly Instructions
PREPARATION PREPARATION Before beginning assembly of product, make sure Estimated Assembly Time: 5 minutes. all parts are present. Compare parts with package contents list and hardware contents list. If any part is Tools Required for Assembly (not included): Phillips missing or damaged, DO NOT attempt to assemble screwdriver the product. - Page 8 ASSEMBLY INSTRUCTIONS Pull back on collar at one end of high pressure hose (N). Locking Spray Gun (before Lance installation) To lock pulling on them. The hose is now securely attached to trigger of spray gun (K), point gun away from you and turn spray gun.
-
Page 9: Operating Instructions
OPERATING INSTRUCTIONS • urn the safety lock button on the spray gun to unlocked. While pointing the spray gun in a safe direction, squeeze the trigger on the spray • Unwind the power cord completely and plug gun until there is a steady stream of water, letting into a grounded 120 volt outlet. - Page 10 OPERATING INSTRUCTIONS • If you hear the motor run intermittently when the trigger is not being squeezed, that is normal. The pump is priming itself so it is ready to operate when • The o-rings on the bayonet end of the nozzle should be cleaned regularly and lubricated with non-water soluble grease such as petroleum jelly (not included).
-
Page 11: Care And Maintenance
CARE AND MAINTENANCE Detergents then lock the spray gun by turning the dial to lock (“3” and “9” • Use detergents designed for power washers. Hardware stores or home centers also have power washer detergents for position). • Using the nozzle tip cleaner provided (or an unfolded paper consistency of water in order to prevent clogging your detergent clip), insert the wire into the nozzle hole and move back and bottle and nozzle. -
Page 12: Pump Saver
CARE AND MAINTENANCE • The quick connect nozzles and rotary nozzle are stored on the • Wind the power cord around the L-shaped hooks located on the nozzle holder located on both sides of machine. top of the machine. • The pressure hose is stored on the hose hook located on t •... -
Page 13: Troubleshooting
TROUBLESHOOTING If you have any questions regarding the product, please call customer service at 1-8 PROBLEM CORRECTIVE ACTION Make sure the power washer is OFF. Plug in the electrical cord to a grounded 120 volt outlet (no Unit will not turn on. electrical extension cord should be used).
Need help?
Do you have a question about the COMMAND FLOW 3000 and is the answer not in the manual?
Questions and answers
Dose the pump have oil or dose it come use ready to use
how do you get the detergent to flow out of the tank