Summary of Contents for Challenger Lifts CLHMES-2000
Page 1
2000 lb Engine Stand (CLHMES-2000) 2311 South Park Rd. Louisville, Kentucky 40219 Email: Web site: sales@challengerlifts.com www.challengerlifts.com Office 800-648-5438 502-625-0700 Fax 502-587-1933 IMPORTANT: READ THIS MANUAL COMPLETELY BEFORE INSTALLING or OPERATING LIFT...
IMPORTANT SAFETY INFORMATION WARNING Failure to follow all of these safety instructions can lead to severe injury or death from a sudden loss of the load. Contact the manufacturer using the contact information printed on the back cover of this manual if you have any questions.
Dismounting an Engine ..........................8 MAINTENANCE INSTRUCTIONS ......................9 INSPECTION INSTRUCTIONS ........................9 4.1. Before Each Use of the Engine Stand ......................9 4.2. Periodic Inspection ............................ 9 Maintenance Chart ............................10 CLHMES-2000 Rev. 12/1/23...
2. Use (4) 3/8-24UNF grade 5 capscrews 1” long to fasten Rear Post to Outer Main Tube. Torque to 30-35 ft- lbs. CAUTION! Be careful not to let this subassembly tip over backward. If it will not stay leaning forward, use an appropriate means to hold it from tipping backward. CLHMES-2000 Rev. 12/1/23...
Page 7
5. Use (4) 3/8-24UNF grade 5 capscrews 1” long to fasten Front Post to Front Caster Tube. Torque to 30-35 ft- lbs. Front Subassembly Rear Subassembly Main Tube Locking Pin 6. Slide the Rear and Front Subassemblies together by inserting the Inner Main Tube into the Outer Main Tube. CLHMES-2000 Rev. 12/1/23...
Page 8
11. Insert the Mounting Bracket Retention Blocks into the slots in the Mounting Plates and use (8) ½-13UNC grade 8 capscrews ¾” long and (8) ½” grade 9 USS flat washers to fasten them to the Mounting Plate. CLHMES-2000 Rev. 12/1/23...
3. Using a shop crane or other suitable means, capture engine and transfer engine’s weight to equipment being used to move engine. Follow instructions provided with equipment being used to move engine. 4. Carefully detach engine from Mounting Arms. CLHMES-2000 Rev. 12/1/23...
» Check that the Gear teeth and Worm are in good condition and are not cracked, bent, excessively worn, or otherwise damaged. » Check that the Rotation Locking Pins are not damaged in any way and can be easily installed and removed. CLHMES-2000 Rev. 12/1/23...