Download Print this page

Evolve ERLS Installation Manual

Led setback luminaire

Advertisement

Quick Links

ERLS LED Setback Luminaire
Éclairage Routier DEL
Luminaria de Vialidad LED
BEFORE YOU BEGIN
AVANT DE COMMENCER
ARRÊT
ALTO
ANTES DE COMENZAR
Read these instructions and save for future use.
Lisez ces instructions et conservez-les pour une utilisation future.
Lea estas instrucciones y guárdelas para uso futuro.
RISK OF ELECTRICAL SHOCK
Disconnect power before service installation,
or maintenance of the product.
RISK OF INJURY OR DAMAGE
Unit will fall if not installed properly. Follow
installation instructions.
RISK OF INJURY
• The luminaire should be mounted so that
prolonged staring into the luminaire at a
distance closer than 0.50 m is not expected.
• Wear safety glasses and gloves during
installation and servicing.
1
Storage & Handling/ Entreposage Et Manipulation/Almacenamiento Y Manipulación
Store packaged units in a covered dry area
Entreposer les appareils emballés dans un endroit sec et
couvert
Almacene las unidades embaladas en un área cubierta
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Installation Guide / Manuel d'Installation / Guía de instalación
WARNING / AVERTISSEMENT / ADVERTENCIA
RISQUE D'ÉLECTROCUTION
Coupez l'alimentation électrique avant
l'installation ou l'entretien de ce produit.
RISQUE DE BLESSURES OU DE DOMMAGES
L'appareil va tomber s'il n'est pas installé
correctement. Respectez les instructions
d'installation.
CAUTION / ATTENTION / PRECAUCIÓN
RISQUÉ DE BLESSURE
• Ce luminaire doit être installé de manière à ce qu'il
ne soit pas possible de le regarder directement à
une distance de moins de 50 cm.
• Lors de l'installation ou d'un entretien, portez des
lunettes de sécurité et des gants.
Check for damage
Vérifier s'il y a des dommages
Verificar si hay daños
99009693 – DOC-2006184
RIESGO DE SHOCK ELÉCTRICO
Desconecte la alimentación antes del
mantenimiento o la instalación del producto.
RIESGO DE LESIONES O DAÑOS
La unidad se caerá si no está instalada
correctamente. Siga las instrucciones de
instalación.
RIESGO DE LESIONES
• La luminaria debe ser montada de modo
que no se espere una mirada fija hacia esta,
a distancias menores a 0.50 m, por tiempo
prolongado.
• Utilice gafas y guantes de seguridad durante la
instalación y mantenimiento.
Do not impact
Do not stack
Éviter les chocs
Ne pas empiler
No impactar
No apilar
EVO_ERLSLED_inst_R02
Page 1 of 5
(Rev 03/21/24)

Advertisement

loading
Need help?

Need help?

Do you have a question about the ERLS and is the answer not in the manual?

Questions and answers

Summary of Contents for Evolve ERLS

  • Page 1 Installation Guide / Manuel d’Installation / Guía de instalación 99009693 – DOC-2006184 ERLS LED Setback Luminaire Éclairage Routier DEL Luminaria de Vialidad LED BEFORE YOU BEGIN AVANT DE COMMENCER ARRÊT ALTO ANTES DE COMENZAR Read these instructions and save for future use.
  • Page 2 Evolve ® ERLS LED Installation Guide / Manuel d’Installation / Guía de instalación 99009693 – DOC-2006184 Knuckle (K1/S1) Mounting 18-22 ft-lbs 24-30 Nm Remove wiring coverplate and gasket. Insert wires. Slide knuckle on tenon. Tighen three (3) mounting bolts. Insérez les fils. Faites glisser le joint sur le Enlevez le couvercle et le joint de câblage.
  • Page 3 Evolve ® ERLS LED Installation Guide / Manuel d’Installation / Guía de instalación 99009693 – DOC-2006184 Horizontal Tenon Mounting >1.87”/48mm OD ~110° 2X/4X ~110 1.63” OD 42mm min. 2.37” OD 60mm max. Open Door Open clamp to pipe OD. Remove bird shield for large pipe.
  • Page 4 Evolve ® ERLS LED Installation Guide / Manuel d’Installation / Guía de instalación 99009693 – DOC-2006184 Wiring/Câblage/Cableado Connect dimming wires Connect supply wires. Extend wires past pipe Connectez les fils de gradation Étendre les fils hors du tuyau. Connectez les fils d’alimentation.
  • Page 5: Specifications/ Spécifications/Especificaciones

    Evolve ® ERLS LED Installation Guide / Manuel d’Installation / Guía de instalación 99009693 – DOC-2006184 Cleaning/Nettoyage/Limpieza 5-10 PSI pH 6-8 35-69 Kpa Use mild soap/detergent. Rinse with cool low pressure water. Wipe dry with clean soft cloth. Utiliser un savon doux/détergent. Rincer à l’eau froide basse pression. Essuyer avec un chiffon doux et propre.