Related Manuals for ZKTeco ZKX10080
Summary of Contents for ZKTeco ZKX10080
- Page 1 Installation Guide ZKX10080/ZKX100100 Micro Dose X-ray Security Inspection Device Version: 1.0 Date: Nov, 2018...
- Page 2 1. Unpacking ① Open wooden box, then open the side panel with the triangle key, loose the screws used to fix X-ray machine with the bottom plate. ② Use a wrench to turn the bottom support foot cups down until the machine is separated from the wooden bars.
- Page 3 2. Assemble Shelf ① Connect the truss to the shelf. ② Adjust the height of the shelf. ③ Fix shelf to X-ray machine with M6*20 screws. ① ② Adjust height Fix with M6*20 screws ③...
- Page 4 3. Wiring ① Open the back door of the console with the triangle key, unscrew the thin metal round nut at the front end of the bellows, and fix the bellows with the thin metal round nut to console. ② Connect the power cables, VGA cable, DB15 cable, and USB cable in the bellows to its interfaces in console.
- Page 5 4. Boot Connect the power cord of ZKX10080/ZKX100100 to the mains. ① After making sure the lines is connected well, you can reverse the key ② switch to "ON", then press the start button next to it and wait for the device to start.
- Page 6 5. Check Scanned Image Put a parcel on the belt at the entrance and use the mouse to click on the ① "Forward" direction key to move the belt forward. When the parcel goes through the tunnel, the scanned image will appear ②...
-
Page 7: Power Off
6. Power Off When turning off, you should reverse the key switch from "ON" to "OFF". ① Note: Do not unplug the power cable of the device before the device is shut down completely. The screen will show "Shutdown" followed by the prompt "Windows will ②... - Page 8 © Copyright 2018.ZKTeco Inc. ZKTeco Logo is a registered trademark of ZKTeco or a related company. All other product andcompany names mentioned are used for identification purposes only and may be the trademarks of their respective owners. All specifications are subject to change without notice. All rights reserved.