Introduction This manual is intended primarily for the trained technician to install, disassemble, or maintain the Hyena e-bike system only. Please read all the safety warnings and instructions carefully. Failure to follow the warnings and instructions may result in death or severe injuries. Save this manual for future reference. Product Features Product Description BE-B180 battery has a small, lightweight design that fits in the same size as a regular water bottle and can be...
Pin Definition Charge (8 pins female, connect to charging socket) Name Direction Description Remark Output Power output Output Ground output Reserve Reserve Reserve Reserve Output Thermistor Voltage Reserve Discharging port (8 pins male) Name Direction Description Remark Output Power output Output Ground output Black...
Page 6
Discharging cable Pin 1 Pin 2 Pin 1 Name Pin 2 Direction Description Remark BAT+ Output Power Output BAT- Output Ground Output Bike Low: power appears at power saving mode. Input High: power disappears at power saving mode. Present Wake Up Input Active low, used to wakeup battery from shutdown mode.
Technical Data Battery Function Rated voltage 36.3V Typical capacity 4.4Ah Energy content 159.7Wh Cut off voltage Charging mode CC-CV (constant voltage with limited current) Charge voltage 42.0V Charge current Normally Continuous discharge current 9.8A RSOC>30% at ±2℃ Weight (approx.) 1.2 kg (2.65lb) Waterproof level IP45 Characteristic...
Mounting Tool List Screwdriver Accessory List Bottle cage & screws (optional) 1 set Rubber strap 1 pc Mounting Instructions • Use the proper bicycle tools during the installation or removal process. • Carefully install this product is necessary; do not strike it with any tool such as a hammer or wrenches. CAUTION! Please strictly follow these steps for assembly;...
Page 9
STEP STEP Tie the rubber strap over the battery and cage back. Adjust the rubber strap to ensure the battery is secured. HYENA E-BIKE SYSTEMS...
Battery Charging Indicator Operation (English) When charging the battery, the battery capacity indicator shows the charging status. Battery Capacity Indicator The indicator shows how much capacity is left in the battery. The indicator lights up in a back-and-forth sequence as 5 LEDs indicate the battery capacity.
Operation Instructions • Do NOT use the battery charger with commercially WARNING! Only charge the battery by following all safety available electrical transformers (travel converters) for descriptions. Also, please read and follow the instructions overseas use. They may damage the battery charger. for using the battery charger.
Charging Instructions • The type of socket for the charge connector might differ • Check your battery pack before using it for the first time. on the different battery types. Please refer to the battery First, you must turn on the battery pack; if the charging instructions.
Safety Instructions does not fit the outlet, have a proper outlet installed by a qualified electrician. Instructions Pertaining to A Risk of Fire, Electric Shock, Or Injury to Persons Moving and Storage Instructions WARNING! When using the BE-B180 e-bike battery, basic •...
Product Label You can find simple descriptions of safety warnings on the product label (shown in the below picture) at the bottom of the battery. Disposal • In accordance with Directive 2012/19/EU and Directive 2006/66/EC, respectively, electronic devices that are no longer usable and defective/drained batteries must be collected separately and recycled in an environmentally friendly manner.
Indicateur de charge de la batterie Operation (Français) Lors de la charge de la batterie, l'indicateur de capacité de la batterie affiche l'état de la charge. Indicateur de capacité de la batterie L'indicateur montre combien de capacité reste dans la batterie. L'indicateur s'allume dans une séquence de va-et-vient comme 5 LEDs indiquent la capacité...
Instructions d'utilisation d'alimentation. (NE PAS endommager, modifier, plier de force, AVERTISSEMENT! Ne chargez la batterie qu'en suivant tordre, tirer dessus, les rapprocher d'objets chauds, placer des toutes les consignes de sécurité. De plus, veuillez lire et suivre objets lourds dessus ou les attacher étroitement ensemble.) les instructions pour l'utilisation du chargeur de batterie.
Instructions de charge la fiche de charge ne s'adapte pas au port de charge. • Vérifiez votre pack de batterie avant de l'utiliser pour la • Le type de prise pour le connecteur de charge peut varier selon première fois. Tout d'abord, vous devez allumer le pack de les différents types de batteries.
Instructions de sécurité AVERTISSEMENT! Une connexion incorrecte du conducteur de mise à la terre de l'équipement peut entraîner un risque de Instructions relatives à un risque d'incendie, de choc électrique. Consultez un électricien qualifié si vous avez des choc électrique ou de blessures corporelles doutes quant à...
Étiquette du produit Vous pouvez trouver des descriptions simples des avertissements de sécurité sur l'étiquette du produit (comme indiqué sur l'image ci-dessous) située au bas de la batterie. Élimination • Conformément à la Directive 2012/19/UE et à la Directive 2006/66/CE, les dispositifs électroniques qui ne sont plus utilisables et les batteries défectueuses ou épuisées doivent être collectés séparément et recyclés de manière respectueuse de l'environnement.
Page 20
Hyena Inc. Tel: +886 4 23598810 Fax: +886 4 23598610 www.hyena-ebike.com Address: No.25, Jingke N. Rd., Nantun Dist., Taichung City 408, Taiwan (R.O.C.) HYENA E-BIKE SYSTEMS...