boblov P15S-0540 - Digital Night Vision Monocular Manual

INTRODUCTION

COMPONENTS

1. Objective Cover
2. Objective Focus Wheel
3. Infrared lamp
4. Tripod socket
5. TF card
6. OUT ] Outlets
7. SB2.0 socket (charging)
8. Picatinny rail
9. Battery compartment
10. Dioptre ring
11. Blindfold
12. Eyepiece cap

Battery Installation

Power On

• Take the objective cover and eyepiece cap down.
• Long press, look through Eyecup#11, the monocular works well if the screen is lightened and icons are shown normally (Pictured at right).
• Icons description
  
  1. Battery charge indicator
  2. Image Capacity Remaining
  3. Current mode(Photo shooting)
  4. TF card in

Power Off

Scenery Observation

• Remove the objective cover, in the observing (photo shooting) mode, aim the objects which need to be observed, look at the screen from Eyecup#11.

1. Adjust the diopter ring#l Oto get the sharp images.
2. Adjust the objective focus wheel#2 to get the sharpest image.

• Automatic fine-tuning control is operated by monocular itself according to the average brightness of scenery centrally.
• Press and to have digital zoom ranged at 1X to 8X. There isn't any obvious mosaic images on the screen.
• If the light resource is enough, the monocular works normally without the auxiliary light on.
• On the contrary, the auxiliary light could be turned on automatically to the brightness default 5. NL5 is shown on the screen.

Announcements
Don't block the auxiliary light.

Brightness Adjustment

• Press in the observing (Photo shooting) mode.
• Enter the brightness adjustment menu, just as the picture at right showed, the number after "Bright:" means the current brightness of screen.
  
• Press the button to position (*) before the "Bright:"
• The brightness ranged at 1 to brightest 9 by pressing and
  

Adjustment for Illumination

• In the observing (photo shooting and videoing) mode, press to enter the auxiliary light adjustment menu.
• The index after Lamp is the brightness of auxiliary light just as the picture showed. Press the button to position (*) before the "Lamp".

• Press , to adjust the infrared illuminator ranged at 0-9(9-lightest, 0-turn off).
• In the state of illuminator on, when you exit the menu, "NLX " will be flickered. "N" is the IR brightness index.
• The auxiliary lighting of this product has two states: automatic and manual. The default state is automatic when starting up. The system can automatically adjust the auxiliary lighting gear according to the brightness of the environment. Enter the manual state when the auxiliary lighting is set through the button, and the lighting gear can be adjusted according to personal preference. If NL is set to 0, the automatic mode will be turned off, and NL must be set to 1 or above manually when used in dark environment (note: the automatic mode has been turned on at this time).
  

Announcements
In any mode above, the menu will be disappeared and go back to photo mode if there isn't any operation within 5 seconds.

Photo Mode

Playback Mode

• In the observing mode, press twice to use the playback function.
• Icons Instructions
  

1. Battery Life
2. No. of Photos
3. Current Mode(Playback)
4. TF card in

• Menu Instructions
  
  1. Battery Life

2. Shooting Date
3. Shooting Time
4. Current No. of photo
5. Playback
6. Video Playback
7. VGA Video Format
8. TF card in

• In the playback mode, press and to view the photos and videos.
• The playing order of photos and videos is based on the shooting order.
• Press to play the video and repress to stop it.
• Press to Exit playback status.

Video Mode

• In the observing mode, press to get into the video recording mode.
  Menu Descriptions:

1. Battery Life
2. Timekeeping
3. Current Mode
4. TF card in

• Press to start shooting, icon 2 turns into the timekeeping and the monocular records the video automatically.
• Press stop Recording the video
• In the shooting mode, the video clips will be saved in the TF card automatically.
• The available time is counted by the storage of TF card, the error may cause.
• Press twice to back to observe status.

Time Setting

Press to enter the menu, press it again to choose time sett, press or to set it. and are used to change the index, press to switch the year, month, day, hour and minute. Press GM again to exit the menu.

Deletion

In playback mode, press to show the deletion menu below, switch YES and NO by and , works to confirm the selection, press to exit the deletion mode.

Monitor Connection

• Connect the monitor to video output interface #6 to switch the display on the screen of external monitor.
• The display inside the monocular is shut down then.

PC Connection

• The viewer is equipped with USB 2.0 interface, connecting with computer by USB cable.
• PC would identify the monocular automatically and read the content in the TF card.
• The data transmission to computer should on the premise that the viewer must be with a batter in and the power should be on.

POWER INSTRUCTIONS

Auto Power Off

• The monocular will be turned off if there is not any operation within 3 (or 10) minutes.
• The monocular won't be turned off automatically in the video shooting and playback mode.

Battery Type

Large capacity rechargeable battery, 750mAh, 3.7 V

External Power

• The monocular would work continuously and won't be turned off automatically when connecting with the external power source.
• The battery would be charged when the monocular connects with external power source.

Announcements
Standard mobile charging source can be used for this monocular. 1Aor 2A mobile power supply is recommend to use.
The monocular is charging when connecting with the computers.

BASIC PARAMETERS

Type	Items	Index
Optical Performance	Magnification	5
	Dimension of Objectives	40 mm
	FOV	5ºx3.75º
	Ocular Adjustable Range	± 0.6
	Observing Distance (Low Light Environment)	~ 2m ~
	Observing Distance (Dark Environment)	~ 200m
Power	Operating Voltage	3.7V DC
	Replaceable Battery	Lithium-ion rechargeable battery
Other	Measurement (L*W*H)	200x86x 56 mm
	Weight	400g

CONFIGURATION STANDARD

Operating Environment

Operating Environment and Announcements

• Keep the monocular in its soft pouch. When not in use.
• Operating temperature ranged at -5-400C. Relative humidity is 80%.
• In order to avoid the wetness and mildew, please keep it in the clear and dry environment. Avoiding the great pressure and solar radiation also please.
• When the image jitter happens or the LCD couldn't be lighten, please charge the battery in time.
• Blow away the dusts before wipe the optical surface. If the monocular won't be used for a long time, please keep charging the battery occasionally to avoid the effectiveness lose.