MCD350 MCD350 SACD/CD PLAYER SERIAL NO. AFL1001 And Above M C D 3 5 0 S A C D / C D P L A Y E R TIME DISC LAYER BACK NEXT STOP PLAY PAUSE OPEN CLOSE STANDBY ON...
4Hz to 20,000Hz, ±0.5dB (CD) 240 Volts, 50/60Hz at 35 watts Standby: Less than 0.5 watt Signal to Noise Ratio Note: Refer to the rear panel of the MCD350 for the correct Better than 108dB (A-weighted) voltage. Dynamic Range Overall Dimensions Better than 100dB Width is 17-1/2 inches (44.4cm)
MCD350 MCD301 REAR PANEL NOTES . The heavy notes on the schematic denote the primary 4. On PC board drawings, Square pad indicates: AUDIO OUTPUTS signal path. a. Polarized Capacitors - Positive POWER CLASS 1 CONTROL DATA b. Diodes - Cathode LASER PRODUCT 2.
MCD350 BLOCK DIAGRAM MCD350 BLOCK DIAGRAM SACD/CD TRANSPORT DIGITAL DISC 16MB 16MB EEPROM EEPROM FLASH SDRAM MEMORY INTERFACE SPINDLE DETECT PROCESSOR MOTOR OPTICAL SWITCH PICK UP DIGITAL UNIT CONTROL FPGA INTERFACE RECEIVER LASER DIODE/ FRONT END PHOTO RF AMP/ DETECTOR/...
Page 6
INTERCONNECT 120V AC PRIMARY LINE VOLTAGE 50/60Hz 100-120VAC 50/60Hz 35W T630mAL 220-240VAC 50/60Hz 35W T315mAL DIGITAL POWER TRANSFORMER N2901 N2902 PRIMARY LINE VOLTAGE MAIN 100-240VAC 50/60Hz 35W T1AH AC POWER CX292 CX291 CY101 ANALOG POWER CD CHANGER MECHANISM N1101 DIGITAL N2701 CX071 CA13...
Page 7
MCD350 MAIN 752023 SCH 1 of 2 3.3VA 3.3VA J6:1 OMUTE J6:3 J6:2 AMUTE 15VA 15VA 4.75k J6:5 AGND 100k J6:4 AGND J6:6 -15VA -15VA J6:7 POWER ON/OFF J11:2 J11:3 BU3.3V J11:4 BU3.3V J11:1 1.5k IR IN R/Cext Cext REM IN J1:8 P4.1/TRIG...
Page 12
AC POWER 752024 SCH and PCB PRIMARY LINE VOLTAGE 100-120VAC 50/60Hz 35W T630mAL 220-240VAC 50/60Hz 35W T315mAL MAIN CONVERSION 120V B (BLK) J1:1 J6:1 20V B (BLU) J1:2 J6:2 0V B (GRY) J1:3 J6:3 120V A (VIO) J1:4 J6:4 100V A (ORN) J1:5 J6:5 0V A (WHT)
MCD350 PARTS LIST INTERCONNECT Ref. No. Description Part No. Ref. No. Description Part No. CAP ELECT 100UF 25V SMD 066605 CABLE ASSY RECEPTACLE/GND WIRE 171723 CAP MONO .1uF 50V +/- 20% X7R SMD 061365 C/A AC INPUT WHT/BLK 173115 CAP MONO .1uF 50V +/- 20% X7R SMD...
Page 18
PARTS LIST (Cont’d.) MAIN PCB 752023 (Cont’d.) Ref. No. Description Part No. Ref. No. Description Part No. RES TF 47.5K 1% 0.125W SMD0805 145132 TERMINAL PC MOUNT 4-40 118115 RES TF 47.5K 1% 0.125W SMD0805 145132 CONN 12 PIN FFC SMD 118001 JACK HEADPHONE STEREO 1/8IN 117945...
Page 19
MCD350 PARTS LIST (Cont’d.) MAIN PCB 752023 (Cont’d.) Ref. No. Description Part No. Ref. No. Description Part No. RES MF 1.65K 1% 1/4W 144516 CAP ELECT 10UF 50V SMD 066602 RES MF 1.65K 1% 1/4W 144516 CAP MONO.1uF 50V +/-20% X7R SMD...
Page 20
PARTS LIST (Cont’d.) DISPLAY PCB 752022 (Cont’d.) Ref. No. Description Part No. Ref. No. Description Part No. RES SMD0805 150 1/8W 1% 145019 CAP MPF 0.033UF 100V 10% 064427 RES SMD0805 33.2 1% 1/8W 144729 CAP MONO .1uF 50V +/-20% X7R SMD 061365 RES SMD0805 150 1/8W 1% 145019...
Page 21
MCD350 PARTS LIST (Cont’d.) ANALOG POWER PCB 752025 (Cont’d.) Ref. No. Description Part No. Ref. No. Description Part No. RES MF 2.74K 1% 1/4W 144587 CAP MONO .1uF 50V +/-20% X7R SMD 061365 RES SMD0805 8.25K 1/8W 1% 145009 CAP MONO .1uF 50V +/-20% X7R SMD 061365 RES SMD0805 22.1K 1/8W 1%...
Page 22
PARTS LIST (Cont’d.) DIGITAL POWER PCB 752026 (Cont’d.) Ref. No. Description Part No. Ref. No. Description Part No. RES TF 620 1% 0.1W SMD0805 145119 RES SMD0805 68.1K 1/8W 1% 145035 RES TF 10K 1% 0.1W SMD0805 145061 RES TF 100K 1% 0.1W SMD0805 145062 RES TF 360 1% 0.1W SMD0805 145081...
MCD350 REPACKING INSTRUCTIONS Quantity Part Number Description In the event it is necessary to repack the 033838 Shipping carton only equipment for shipment, the equipment must be 033837 End cap packed exactly as shown below. It is very important that the four plastic feet are attached to the bottom of the equipment.
Page 24
MCD350 SACD/CD PLAYER SERIAL NO. AFL1001 And Above The continuous improvement of its products is the policy of McIntosh Laboratory Incorporated, who reserve the right to improve design without notice. Because of the constant upgrading of McIntosh products’ circuitry and components, the Company cannot insure, and does not warrant, the accuracy of the within schematic material, which is intended for information only.