Advertisement
Quick Links
Advertisement
Summary of Contents for Dolphin PRO
- Page 1 Dolphin PRO/PRO2/PRO3 Installation Guide Structure of Dolphin Pro/Pro2 T Top...
- Page 2 Structure of Dolphin Pro3 T Top EXPLODED VIEW OF THE DOLPHIN PRO/PRO2 T TOP FOR REFERENCE...
- Page 3 EXPLODED VIEW OF THE DOLPHIN PRO3 T TOP FOR REFERENCE STEP 1: Unpack and check the contents of the box and check parts list. Please Read all Instrustion prior to installation If you are NOT sure of any part of the guide or you have any questions...
-
Page 4: Parts List
PARTS LIST STEP 2: Positioning of the lower half of the side frame. Distance from the centre console to lower side frame (1inch to 7inch) Check under the floor for wires or other objects that could effect the mounting Place the lower half of side frame in the desired postion and mark as a reference Remove the side frames and Measure the distance between the front mounting position from Port to Starboard (side to side) Right this measurement down... - Page 5 STEP 3: Assemble the side support frame Attach the lower half and upper half of the side frames using the bolts and split washers. Note the Dolphin logo faces outwards from the boat Note the bolt heads will be consealed in the counter sunk area and face inwards towards the console.
- Page 6 NOTE: For Pro3 t top, there is 2 smaller clamps which must be assembled onto the 3rd bow of the top frame for attaching the 2 large handles. But please don't attach the handles at this time. Keep the clamps movable until you install the legs and find the exact position where you can tighten it. STEP 5: Assember the front and centre section of the top frame Note the shape of the front section is narrow and also has a bend curve which faces downwards when attached to the side support frames of the T Top.
- Page 7 IMPORTANT: These small holes should be at the same side of each bow otherwise it is not a correct installation and you may meet trouble when attach the top frame to the legs. STEP 6: Attach the Side Supports to the Assemble Top Section Check the direction of the side support arms Logo to the outside, handle to the rear The small curved top frame for the cover curves and bends downwards to the floor Remove the tops of the ball clamps please NOTE the clamps are to be placed on the same way (they are...
- Page 8 STEP 7: Attach the T top to the floor of the boat Place the T Top you have assemble on the marks you have made near your console Now you can pre drill and use the bolts and backing plates and lock in you mounting points NOTE: Check under the !oor for any wires or objects before drilling holes.
- Page 9 STEP 9: Attaching the cover to the top frame. Remove the cover and lay out on the ground. Note: there is a zipped front pocket which is zippered from side to side. Place this over the front section of the T top and zipper up now you can fold out over the rest of the top frame and hook over the back and zipper this section up and the velcro corner sections.
Need help?
Do you have a question about the PRO and is the answer not in the manual?
Questions and answers