Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Labgear 76611PI
- Page 1 76611PI 5-in-1 Diagnostic Cable Tester...
-
Page 2: Panel Layout
1. Introduction The Labgear 5-in-1 Diagnostic Cable Tester tests 5 common LAN and Computer cables. It tests computer cables or communication cables with RJ45, RJ11, USB IEEE1394 and BNC connectors. It is intended to test cables with straight through connections, not cables with reversed wiring or transposed connections like some LAN crossover cables or reverse wired telephone cables. -
Page 3: Safety Rules And Warnings
3. Safety Rules and Warnings Don’t store or leave the unit in direct sunlight, especially under glass. Don’t store in damp or excessively dusty environments or temperatures over 40oC. Use only 9V alkaline battery of good quality. Remove the battery if the meter is not to be used for an extended period. -
Page 4: Operation
6.2. The MAIN and REMOTE Unit The Labgear 5-in-1 Diagnostic Cable Tester consists of a main unit and a remote unit. The remote unit stores conveniently on the bottom of the main unit. It can be removed or replaced by sliding it from left to right. - Page 5 • When testing an RJ45 UTP Cables the S/G LED must not light up. • When testing an RJ45 FTP/STP Cable the S/G LED must light up. • The Labgear 5-in-1 Diagnostic Cable Tester is intended to test complete cable. It may not find faults in cables that are intentionally incomplete.
-
Page 6: Cable Repair
While the Labgear 5-in-1 Diagnostic Cable Tester can identify a bad cable, it cannot determine if the wire or the connectors are at fault. The user must examine the different parts of the cable to determine the cause of the failure and take the appropriate action to correct the problem. - Page 7 Not all LAN cables are wired straight through. Crossover cables used on LANs are purposely miswired, with their Receive and Transmit wires cross over. The Labgear 5-in-1 Diagnostic Cable Tester will test this as a bad cable, but it may work fine as a crossover cable.
-
Page 8: Maintenance
Many telephone cables with RJ11 plugs/jacks are wired in reverse. The Labgear 5-in-1 Diagnostic cable Tester will show that a cable like this is crossed. A cable like this reverses the polarity of the telephone line. Most regular telephones made in the last 20 years are not polarity sensitive. - Page 9 9. Accessories Your Labgear 5-in-1 Diagnostic Cable Tester includes the following items: • Main Unit • Remote Unit • Female BNC Terminator • Male/Male BNC Jumper Cable • Male/Male RJ11 Jumper Cable, 4-wire • Male/Male RJ45 FTP/STP Jumper Cable EIA/TIA 568 •...
- Page 12 Check with your local authority for recycling advice. Distributed by EU Distributor Philex Electronic Ltd., Philex Electronic Ireland Ltd., Kingfisher Wharf, Robwyn House, Corrintra, London Road, Bedford, Castleblayney, Co. Monaghan, MK42 0NX, United Kingdom A75 YX76, Ireland. sales@labgear.co.uk © Philex Electronic Ltd. 2023. V1.1 www.labgear.co.uk...